8 [Administration] Tab Page146 [Setup] Item List Setting up Date & TimeYou can set the date, time, time zone, and date format.[Date & Time] settings are not available if the SNTP function is enabled. Setting up SNTP ServiceIn SNTP Service, you can specify the SNTP server to refresh the time settings of this equipment using SNTP service.Item name Description1 Year/Month/Date/Time Select the year and month in designated boxes. Also, enter the date and time in designatedboxes.2 Time Zone Select the time zone where this equipment is located.3 Date Format Select the date format.Item name Description1 Enable SNTP Select whether to enable or disable SNTP (Simple Network Time Protocol). When this isenabled, the time settings of this equipment can be adjusted using the SNTP service.[Date & Time] settings are not available if enabled.2 Primary SNTP Address Enter the IP address or FQDN (Fully Qualified Domain Name) of the Primary SNTP ServerAddress when [Enable SNTP] is enabled.3 Secondary SNTP Address Enter the IP address or FQDN (Fully Qualified Domain Name) of the Secondary SNTPServer Address when [Enable SNTP] is enabled as required.When the [Obtain a SNTP Server Address automatically] option is enabled in the TCP/IP settings, the SNTP server addresscan be obtained using the DHCP server.P.148 “Setting up TCP/IP”4 Scan Rate Enter how often this equipment should access the SNTP server to check the time.5 Port Number Enter the port number for the SNTP service. Generally "123" is used.6 NTP Authentication Select whether to enable or disable NTP authentication.123123456