8 [Administration] Tab Page154 [Setup] Item List Setting up AppleTalkYou can set the protocol to enable communication over AppleTalk. AppleTalk must be configured to enable AppleTalkprinting from Macintosh computers. Setting up BonjourIn Bonjour, you can enable or disable the Bonjour networking that is available for Mac OS X.Item name Description1 Enable Apple Talk Select whether the AppleTalk protocol is enabled or disabled. Enable this when configuringAppleTalk printing. [Disable] is set as the default.2 Device Name Enter the device name of the equipment that will be displayed in the AppleTalk network. Youcan enter up to 32 alphanumerical characters and symbols other than =, ; (semicolon), #,and \ (backslash).3 Desired Zone Enter the zone name where the equipment will connect — if required. You can enter up to 32alphanumerical characters and symbols other than =, ; (semicolon), #, and \ (backslash).The equipment will connect to the default zone if you enter "*".Item name Description1 Enable Bonjour Select whether Bonjour is enabled or disabled. [Enable] is set as the default.2 Link-Local Host Name Enter the DNS host name of this equipment. You can enter up to 127 alphanumericalcharacters and symbols other than =, ; (semicolon), #, and \ (backslash).3 Service Name Enter the device name of this equipment that will be displayed in the Bonjour network. Youcan enter up to 63 alphanumerical characters and symbols other than =, ; (semicolon), #,and \ (backslash).123123