8 [Administration] Tab Page168 [Setup] Item List Setting up FTP ServerIn FTP Server, you can enable or disable the FTP server functions.Item name Description1 Enable FTP Server Select whether the FTP server is enabled or disabled. Select [Enable] to enable thefollowing functions.y FTP printingy Reading/writing the address book data using the Address Book Viewery Backing up/Restoring the e-Filing data using the e-Filing Backup/Restore Utility[Enable] is set as the default.2 Enable SSL Select whether the SSL (Secure Sockets Layer) is enabled or disabled for the FTP server.[Disable] is set as the default.Not all operating systems support SSL for all protocols.3 Default Port Number Enter the port number for the FTP server. You can enter a value in the range from 1 to65535. Generally the default value "21" is used.When the same port number as the secondary one in the HTTP setting (SSL port number when SSL in the HTTP setting isenabled) is selected, you cannot access TopAccess or the e-Filing web utility. If you set it by mistake, use the control panel ofthe equipment to change the HTTP setting and enter the correct port number.4 SSL Port Number Enter the port number that is used to access this equipment using FTP with SSL. The portnumber depends on the port setting in the FTP server. You can enter a value in the rangefrom 1 to 65535. Generally the default value "990" is used.When the same port number as the secondary one in the HTTP setting (SSL port number when SSL in the HTTP setting isenabled) is selected, you cannot access TopAccess or the e-Filing web utility. If you set it by mistake, use the control panel ofthe equipment to change the HTTP setting and enter the correct port number.1234