Connecting to a Computer- 54 -Memo If the machine is not displayed by clicking [Restartsearch], select [Printer name/IP Address] andenter the IP address assigned to your machine, andthen click [Next].11 If the [Windows Security] dialog boxappears, click [Install this driversoftware anyway].12 Click the [Exit] button.13 Remove the "Software DVD-ROM" fromthe computer.The installation is complete. Print a test page to check that the printerdriver is successfully installed on thecomputer.1 Click [Start] > [Devices and Printers].2 Right-click the OKI MB491 icon andselect [Printer properties] (> a desiredprinter driver if you have installedmultiple drivers) from the pop-up menu.3 On the [General] tab, click [Print TestPage].Installing a Printer Driver(For Mac OS X)To complete the network connection with a Macoperating system, install a printer driver on thecomputer and set your machine as a networkprinter.Select the protocol for your network connectionfrom the following: EtherTalk BonjourNote EtherTalk is not supported in Mac OS X 10.6 or later. Disable the anti-virus software before starting thisprocedure. EtherTalk is not supported in Mac PCL. Using EtherTalk (For Mac OS X10.5)When connecting to the network with EtherTalk,it is necessary to enable EtherTalk in themachine. Then, install the driver in the computer. First, enable EtherTalk in the machine.1 Ensure that your machine and thecomputer are turned on and connected.Reference "Connecting an Ethernet Cable" P. 472 Press the <SETTING> key on theoperator panel.3 Press the to select [Admin Setup],and press .4 Enter the administrator password.The factory default password is "aaaaaa".5 Select [Complete], and press .6 Press the to select [Network Menu],and press .7 Press the to select [Network Setup],and press .8 Press the to select [EtherTalk], andpress .9 Press the to select [Enable], andpress .10 Press the until the top screen isdisplayed.OKOKOKOKOKOK
