43967002TH Rev.1 245 /Oki Data CONFIDENTIAL 5. Maintenance Menu5.10.3.5 Test printThis self-diagnostic menu is used to print the test pattern contained in the PU. Other testpatterns are contained in the controllerThis test print cannot be used to check the print quality.To diagnose the abnormal image, refer to item 7.1. Enter the self-diagnostic mode (Level 1) and press the (2) key or (8) key until[TEST PRINT] is displayed in the top of the screen. Then, press the (6) key. (The(2) key increments the test item and (8) key decrements the test item.)2. The setting items that are applicable to the test print only are displayed inthe lower column of display window. Press the (2) key or the (8) key until thecorresponding item is displayed. Then, press the (6) key. (The (2) key incrementsthe item and (8) key decrements the item.) (When the setting value for each itemis not required [Default setting], advance to item 2.)3. Keep pressing the (2) key or the (8) key, and press the (6) key at the item thatis set in item 2. The setup item is displayed in the upper column, and the settingvalue is displayed in the lower column of the display window. Pressing the (2)key increments the setting value. Pressing the (8) key decrements the settingvalue. (The setting value that is displayed last is applied.) Pressing the (4) keydetermines the setting value, and the screen returns to item 2.) Repeat item 3as required.Display Setup value FunctionPRINT EXECUTE – Pressing the (4) key starts printing/Pressingthe (#) key ends printing (in page unit).TEST PATTERN 0 0 White paper print1 to 7 Refer to next page. (Pattern print)8 to 15 White paper printTEST CASSETTE TRAY1 Select the paper feed source.If TRAY2 is not installed, TRAY2 is not displayed.TRAY2MFPPAGE 0000 Setting the number of test prints.COLOR ON Selecting color or monochrome print.* ON is specified, ON/OFF setting for each colorappears.OFFDUPLEX 2 PAGES STACK Duplex print is executed with two sheets stack.Duplex print OFF selectDuplex print is executed with single sheet stack.OFF1PAGES STACKMONO SPEED LOW Selecting monochrome print speed.LOW: 30ppmHIGH: 34ppm(A4),33ppm(Letter)HIGH• is the initial value. The set item is valid in this test mode only.(It is not saved in EEPROM.)Note!PAGE setting …………………… Pressing the (2) key or the (8) key shifts the digit. When the () key is pressed, the setting value increments. Pressing the # keydecrements the setting value. If test print is executed with the printnumber setting “0000”, print will continue infinitely. Be careful not toset “0000”.COLOR setting …………………… When the (6) key is pressed while set to ON, the following contentsare displayed on the panel screen.Print setting of each color………… Pressing the (2) key or the (8) key shifts the value.Pressing the ( ) key or the (#) key enables operator to switchbetween ON and OFF setting.Pressing the (4) key returns the screen to operator panel display.
