43967002TH Rev.1 261 /Oki Data CONFIDENTIAL 5. Maintenance Menu5.12.2 Special startupThe special startups that are supported by MC860 are shown below.Input code Special mode100 Flash ROM forced initializationInitializes all of the installed Flash ROM forcibly.Forced initialization is possible only when the Service call 042 to 043 is issued.101 Parameter forced initializationParameters are initialized forcibly in the case when the Service call 081 isissued if EEP-ROM and Flash cannot be written or read normally, or if any core-open parameter information is damaged.102 Additional component ignoreMFP can be started up without loading the additional component by using theDLM (Down Load Module) function even if additional component has beenstored in Flash ROM.103 Download mode startupMFP starts up in the download only mode of the additional component. Atpresent, additional component can be downloaded via Soft NIC only.When the Soft NIC module is going to be newly added, the MFP should start upin this mode.104 Debug modeStarts up the ROM debugger or the Target Shell.105 ON LINE mode alwaysThe errors that moves the MFP into the OFF LINE state are ignored, and the “ONLINE mode always” condition is maintained.106 FUSE KEEP MODEThis is the mode enabling operator to replace the consumable items with newones and checks the MFP operations while the power remains ON.While an MFP is in the FUSE KEEP MODE, the new consumable item fuse willnot be cut, and the operation count is not added to the count value of old parts.When the power of the MFP is turned OFF, MFP exits this mode. When thepower is turned ON next time, this mode becomes invalid.110 Flash ROM initializationThe resident Flash ROM is initialized in the same way as in the case when thefollowing menus are selected: [Admin Setup] - [Management] – [Flash MemorySetup] – [Initialize].Input code Special mode111 Language initializationThe downloaded message file is initialized in the same way as in the case whenthe following menus are selected: [Admin Setup] - [Management] – [LanguageMaint Setup] – [Initialize].112 Setup value initializationMFP is initialized in the same way as in the case when the following menus areselected: [Admin Setup] - [Management] – [Reset Settings].113 Erasure of individual personal informationIndividual information that is registered in the MFP is erased in the same wayas in the case when the following menus are selected: [Admin Setup] -” [UserInstall] - [Erasure Privacy Data].114 HDD sector checkThe HDD defective sector information is recovered and the HDD file system un-match is recovered in the same way as in the case when the following menusare selected: [Admin Setup] - [Management] – [Storage Maint Setup] - [Sectorcheck]. Management115 HDD file system checkResolves the un-match between the actual (free) space and displayed freespace of file system, and recovers the control data (FAT information) in thesame way as in the case when the following menus are selected: [Admin Setup]- [Management] - [Storage Maint Setup] - [File system check].120 Format HDDHDD is initialized in the same way as in the case when the following menusare selected: [System maintenance] – [Format HDD]. Contents of HDD are allerased.121 Format Flash ROMFlash ROM is initialized in the same way as in the case when the followingmenus are selected: [System maintenance] – [Format Flash ROM]. Contents ofthe resident installed Flash device are all erased.122 Administrator password resetAdministrator password is reset to default setup value in the same way asin the case when the following menus are selected: [System Maintenance] –[Change Password].123 All ResetContents of the EEPROM, Flash ROM and HDD are returned to the defaultvalues in the same way as in the case when the following menus are selected:[System Maintenance] – [All Reset].
