Panasonic AG-3DA1E Operating Instructions Manual

Contents

38PUSHIRIS/CONV. dial DIAL (IRIS/CONV.)selector switch1 Set the DIAL (IRIS/CONV.) selector switchto CONV.With this setting, the camera will adjust theconvergence point (depth of the referenceplane for the 3D image) according to thesetting of the IRIS/CONV. dial.2 Turn the IRIS/CONV. dial to adjust theconvergence point.Tips on convergence pointadjustmentUsing the MIX buttonIf you press the MIX button, the image fromthe left lens and that from the right lens aresuperimposed on the LCD monitor and viewfinder(MIX image).Turn the IRIS/CONV. dial so that the outline of thesubject at the reference plane from the left lens iscompletely aligned with that from the right lens.BARS SHUTTERAUDIOSPEEDINPUTMIC POWER +48V（R）1 2SELWFMRESETCOUNTEREVF DTLMIX ZEBRASELECT CH 2INT ONOFFINPUT 2（L）INTINPUT 1INPUT 2CH 1MIX buttonPress the MIX button again to display theimage shot by the left lens only.The left and right images will not be perfectlyaligned if the subject is located at a distanceof less than . m.The MIX image does not affect the recordedimage.The MIX image is cancelled when thedisplay status is changed, for example,when a menu is changed or REC CHECK isperformed.•••Adjusting the convergence point3D guide functionIf you press the 3D GUIDE button, the viewfinderand the LCD monitor display a guide for thedistance range within which the camera canshoot the subject so as to comfortably reproducea 3D image. The 3D guide display (Page 69)changes as follows each time you press the 3DGUIDE button: no display Guide display 1Guide display no display…When shooting, select the guide displayaccording to the size of monitor you intend to usefor viewing.Guide display 1 (3D indication in white):Target monitor screen size is less than77-type.Guide display 2 (3D indication in green):Target monitor screen size is 77-type orgreater.PUSH3D GUIDE buttonIf you shoot a subject beyond the distancerange shown by the guide display, a doubleimage or strangeness feeling may beproduced, or the shot image may not bereproduced as a 3D image correctly.If the subject is outside the distance rangeshown by the guide display, readjust theconvergence point so that the subject goeswithin the distance range of the guidedisplay.••Convergence displayIf you set CONVERGENCE to ON, on the setupmenu DISPLAY SETUP screen (Page 81), theconvergence display indicates the distancebetween the camera and the adjusted referenceplane as C00 to C99. The larger the number, thegreater the distance to the reference plane.C50