Panasonic AG-3DA1E Operating Instructions Manual

Contents

Menu81AV OUT SETUP screenItem Displaymode Description of settingsSDI OUT (Camera)(PB)Sets whether to output the signal from the HD SDI terminal.ON: The signal is output from the HD SDI terminal. It is not output from theHDMI terminal.OFF: The signal is not output from the HD SDI terminal. It is output from theHDMI terminal.HP MODE (Camera) Selects the sound heard through the headphones.LIVE: The sound which has been input from the microphone is outputas is. This setting is selected when delays in the sound areannoying.RECORDING: The sound in the status which is to be recorded (the soundsynchronized with the images) is output.DISPLAY SETUP screenItem Displaymode Description of settingsZEBRADETECT1(Camera) Selects the brightness level of the left-leaning zebra patterns on the screen.105%, 100%, 95%, 90%, 85%, 80%, 75%, 70%, 65%, 60%, 55%, 50%ZEBRADETECT2(Camera) Selects the brightness level of the right-leaning zebra patterns on the screen.105%, 100%, 95%, 90%, 85%, 80%, 75%, 70%, 65%, 60%, 55%, 50%SAFETY ZONE (Camera) Sets whether to display the safety zone. (Page 69)ON OFFRECCOUNTER(Camera) Selects counter operation during recording.TOTAL: The count continues to increase until the RESET button is pressedto reset it.CLIP: Resets the counter at start of recording and counts the time of eachrecording session.In PB mode, operation is always in CLIP mode.•OUTPUT OSD (Camera) Select ON to output the information displayed on the screen together with thevideo signals.ON OFFTime code, audio lever meter, and focus bar displays are not output.•DATE/TIME (Camera) Sets whether to display the date and time on the screen together with thevideo signals.TIME: The time is displayed.DATE: The date is displayed.TIME & DATE: The date and time are displayed.OFF: The date and time are not displayed.LEVEL METER (Camera) Select ON to display the audio level meter.ON OFFZOOM &FOCUS(Camera) Sets whether to display the zoom and focus values.ON OFFCONVERGENCE (Camera) Sets whether to display the position of the reference plane (relative value).(Page 38)ON OFFindicates the factory setting.