18Chapter7 MenuOperationsItem Setting NotesUSER MAIN Sets the function assigned to the USER MAIN button.REC REVIEW, SPOTLIGHT, BACKLIGHT, ATW,ATWLOCK, GAIN: 24 dB, Y GET, DRS, TEXT MEMO,SLOT SEL, SHOT MARK, MAG A. LVL, PRE REC,PC MODE, WFM, FBCFor details, refer to [Assigning Functions to USERbuttons] (page 61).• When a remote control unit (AJ-RC10G) or extension control unit (AG-EC4G) is connected, the SPOTLIGHTand BACKLIGHT functions are notavailable.USER1 Sets a function assigned to the USER1 button. Thefunctions that can be assigned to this button are thesame as for the USER MAIN button.BACKLIGHT (factory default setting)For details, refer to [Assigning Functions to USERbuttons] (page 61).USER2 Sets a function assigned to the USER2 button. Thefunctions that can be assigned to this button are thesame as for the USER MAIN button.TEXT MEMO (factory default setting)For details, refer to [Assigning Functions to USERbuttons] (page 61).RET SW Sets the function assigned to the RET button on thelens.REC REVIEW, TEXT MEMO, SHOT MARK, INHIBIT• When INHIBIT is selected, the RET button function isdisabled.WFM Selects the waveform displayed in the LCD monitorwhen the user button to which WFM has beenassigned is pressed.WAVE: Displays a waveform.VECTOR: Vectorscope displayWAVE/VECT: Each press of the button, switchesthe settings in the following order: OFF WAVE(waveform) VECTOR OFF.AUTO KNEE SW Selects the function of the OUTPUT/AUTO KNEE.ON: Setting AUTO KNEE to ON turns on the AUTOKNEE function.OFF: The AUTO KNEE function is not available evenwhen AUTO KNEE is set to ON.DRS: Setting AUTO KNEE to ON turns on the DRS(Dynamic Range Stretcher) function. (For details, referto page 12.)• When set to 1080/30P or 1080/24Pmode, selecting DRS produces thesame effect as selecting ON.RECORDING SETUP screenItem Setting NotesREC FUNCTION Sets special recording modes.NORMAL: The special recording modes are not used.INTERVAL: Sets interval recording.ONE SHOT: Sets one-shot recording.LOOP: Sets loop recording.For details, refer to [Special Recording Modes](page 42).• This function is always set to NORMAL when thepower is turned on.• Not available in the followingconditions.- When REC SIGNAL is set to 1394- When REC FORMAT is set to nativerecording.- When SYSTEM MODE is set to 1080-59.94i or 480-59.94i; and CAMERAMODE is set to 24P or 24PA.- When compiling to a clip in one-cliprecording mode.____ indicates the factory setting
