Panasonic AJ-HPM100E Operating Instructions Manual

Also see for AJ-HPM100E: Operating instructions Mechanical Parts List Brochure & specs

Contents

106 Setup: Item Settings684 EDH(SD)00000001OFFONSpecifies whether or not EDH is superimposed on serial output signals.0: Signals are not superimposed.1: Signals are superimposed.685 ESR MODE(SD)00000001OFFAUTOSpecifies the operating mode for edge subcarrier reduction (ESR) in the playback circuit.0: ESR is forcibly set to off.1: ESR is automatically turned on and off depending on operating mode.NOTE:• This menu is not displayed when 50 is selected in menu No. 25 SYSTEM FREQ.688 CC REC00000001OFFONSpecifies whether or not the closed caption signal that is superimposed on the SD SDI andanalog composite input signals will be recorded.0: Not recorded.The EE output is also blanked.1: A closed caption signal that is superimposed on an input signal is recorded.NOTE:• This menu is not displayed when 50 is selected in menu No. 25 SYSTEM FREQ.• When 1394 is selected as the input signal, the closed caption signal superimposed onthe compressed input signal is recorded in its original form regardless of settings in thismenu.689 COMP MODE00000001NORMALDARKSelects the compression method used during video recording.0: Records using normal compression processing.1: Records video suppressing compression video distortion that is generated by darkareas that are about 10 IRE (70 mV) or less.NOTE:This setting is available in 720p mode recording.690 UMID REC00000001OFFONSpecifies whether or not UMID data should be recorded.0: UMID data is not recorded.1: Recorded.691 UMID GEN00000001INTEXTSpecifies the generation method of UMID information that is recorded when menu No. 690UMID REC is set to on.0: Newly created UMID information is always recorded.1: Records UMID data superimposed on the input signal.Newly created UMID information is recorded when not superimposed on an input signal.692 UMID POS00000001:0006:0008BLANK12L:17L:19LSpecifies the line that superimposes UMID data.NOTE:• You cannot select the same line as in menu No. 501 VITC POS-1 and No. 502VITCPOS-2.• Holding down the SHIFT button and pressing the RESET button will not restore thefactory defaults.• UMID data is output before recorded VANC data. To output VANC data, set UMID POSto a line other than that which superimposed the data or select “BLANK.”• During playback of native clip, UMID becomes BLANK.Item SettingSettings and brief function descriptionFRNo.SUPERDISP.FRNo.SUPERDISP.