Panasonic AJ-HPM100E Operating Instructions Manual

Also see for AJ-HPM100E: Operating instructions Mechanical Parts List Brochure & specs

Contents

122 For Long and Trouble-Free Operation: Error Messages◆ NOTE:*1 This warning appears only during recording.Then the video recording goes black and the audio signal is muted.*2 This warning appears only during recording. Then the audio is recorded mute.*3 This warning appears only during recording. The internally generated time code is recorded.*4 This warning appears at any time. This error disables input to the digital video interface.*5 “E-50” appears when the backup battery is depleted. Consult your supplier for information on a store that can provide you with a new battery(CR2032 or the equivalent). Be sure to use setup menu No. 069 (CLOCK SET) to set the clock after battery replacement.The following warning messages appear when an incorrect operation is attempted in the thumbnail play list screen.Item Message Description MeasureThumbnailsCANNOT ACCESS! Data cannot be accessed because it is corruptedor for other reasons.Restore media and clips to normal state beforeaccess.WRITE PROTECTED! The P2 or SD card is write protected. Insert write-enabled media.CARD FULL! The P2 or SD card is full. Insert media with sufficient capacity.NO CARD! No P2 or SD card is inserted. Insert compatible media.CANNOT DELETE! Contents version mismatch prevents deletion. Match devices and contents version.UNKNOWNCONTENTSFORMAT!Warning displayed to indicate contents versionmismatch.Match devices and contents version.CANNOT FORMAT! P2 card problem prevents formatting. Check P2 card.CANNOT REPAIR! Selected content is normal and cannot berepaired.Check selected content.CANNOT RE-CONNECT!A clip that does not span multiple cannot bereconnected.Check selected content.NO INPUT! No data is input. Set after making input.INVALID VALUE! Entered data was invalid. Enter data in a valid range.UNKNOWN DATA! The metadata character code is invalid. Use UTF-8 for the metadata character code. Use theviewer to enter correct characters.CANNOT REPAIR INSELECTION!Some of the selected clip could not be repaired.NO SD CARD! No SD card is inserted. Insert an SD card.NO COPY TO SAMECARD!A clip cannot be copied to the card storing theoriginal clip.Copy the selected clip to a card that does not containthe original clip.USER CLIP NAMEMODIFIED!Characters in the clip name had to be deleted inadding the counter value.The user clip name plus the counter value can onlycontain up to 100 bytes. Characters in the clip nameare automatically deleted when the total exceeds100 bytes.TOO MANY CLIPS! Too many clips are selected. Reduce the number of selected clips.LACK OF RECCAPACITY!There is not enough recording capacity left on thecard.Insert a card with sufficient recording capacity.HDDHDD CAPACITYFULL!Not enough space left on the hard disk. There is not enough space on the connected harddisk. Use a new hard disk or formatted hard disk.TOO MANYPARTITIONS!There are too many partitions. Hard disks can handle up to 15 partitions. Use a newhard disk or formatted hard disk.HDDDISCONNECTED!The unit is not connected to a hard disk. Reconnect the USB cable. If the hard disk does notoperate normally, turn it off and turn it back on again.CANNOT FORMAT! The hard disk cannot be initialized. Connect another hard disk drive.TOO MANYTARGETS!Multiple devices are connected. Disconnect devices, turn off the unit and turn it backon again.UNKNOWN DEVICECONNECTED!The connected DVD drive is not compatible. Disconnect devices, turn off the unit and turn it backon again.CANNOT ACCESSTARGET!An error occurred during hard disk access. Check hard disk status and connection.