Using Play List: Play List Function 55 Using Play List7. FilenameShows the number of the P2 card slot where thecurrent play list is stored and its filename.8. Start TCDisplays the start time code value for changing thetime code during playback.9. REMAIN(EXTRA)Indicates the remaining time available for voice-overrecording.A play list not saved to a P2 card is indicated in grayand has no time indication.10.P2 card slot number and hard disk drive statusDisplays P2 card and USB hard disk status.➝Refer to “Thumbnail Screen Names and Functions.”You can set whether pressing the STOP button duringplay list playback should return you to the play list afterplayback or not. Use the following procedure to make thedesired setting.1 Open the play list screen.2 Press the MENU button.3 Use the cursor buttons to choose [SETTING] –[STOP MODE].4 Select [RETURN] or [STAY] and press the SETbutton.5 Press the MENU button to end setup.◆ NOTE:• During remote play list playback using a 9-pin cable, set toSTAY and the location will not change when the STOPbutton is pressed.P2 card slot number: FilenameP2 cards slot and file nameare displayed in white:NormalFilename is gray: The file can be loadedbut not edited. To editsuch a file, store it on aP2 card to enableediting.P2 card slot number is red: The card storing thesaved file is notinserted.The file stored on a P2card cannot be found.Stop Mode SetupRETURN: A return is made to the play list screenwhen the STOP is pressed (or whenan automatic stop occurs at the start orend of all events). The cursor positionmoves to the event where the button waspressed.STAY: A return to the play list screen is notmade and a still picture is output whenthe STOP button is pressed (or whenan automatic stop occurs at the start orend of all events).Use this setting when you do not want tochange the playback start location.To return to the event list after makingthis setting, press the PLAY LIST buttonor the EXIT button.
