125Connection with external device : Connection using the SDI IN connector (when AJ-YA350G attached)Connection with external device1 Confirm that the HD/SD-SDI input board (AJ-YA350G:optional accessory) is attached to the unit and thatthe wires are connected properly. For details, refer tothe installation manual for the AJ-YA350G.2 Confirm that the connected device has the samesignal format as the camera-recorder.3 When signals are input from the SDI IN connector, setthe REC SIGNAL in the setting menu to “SDI”. TheREC SIGNAL item will be selected from MODE> on the SYSTEM SETTING page.Notesz If the HD/SD/SDI IN board is not attached, REC SIGNALcannot be set to "SDI".z When nothing is connected to the SDI IN connector orthere is no input signal, images to be recorded will beblack and no sound will be recorded. Input the samesignals as the format set in the SYSTEM MODE item inthe setting menu through the SDI IN connector. If theformats are different, data will not be properly recordedon the P2 card.z Note the following points when the REC SIGNAL of thesetting menu is set to "SDI". Audio signals are input from the SDI IN connector. Audio signals must be input synchronized withvideo images. Data will be recorded as 48 kHz/4CH(16 bit) on a P2 card. When the REC SIGNAL item is set to "SDI", signalsinput from the GENLOCK IN connector are disabledeven if nothing is connected to the SDI IN connector.Please note that there is a delay between videoimages and voice signals when the unit is used on asystem synchronized with the reference.z UMID information, time code and users bits cannot berecorded on a P2 card using the SDI IN connector.Connection using the SDI IN connector(when AJ-YA350G attached)