70 Adjustments and Settings for Recording : Viewfinder Screen Status DisplaysThe center, safety zone, safety zone area and framemarkers may be set to ON or OFF, along withspecifications of the marker types. To set and selectmarkers, go to the VF MARKER screen from the VF pageand select the appropriate options.For directions on navigating the menu, see [Setting MenuOptions] (page 139).NoteThe indication MKR:A at the upper right of the screenshows the current indication status. To view TABLE B,press the MARKER SELECT button. This changes theindication to MKR:B, allowing you to view the settings.The viewfinder can display a screen that allows you to viewthe marker settings of the unit.Pressing the MARKER SELECT button on the camera-recorder switches the marker indication as follows.Marker A > Marker B > No markerIf the menu option FRAME SIG is set to 16:9 as theinformation of Marker A and 4:3 as the information ofMarker B, then the 16:9 and 4:3 view angles can easily bechecked with the button, as required.The viewfinder displays the return video signal input to theGENLOCK IN connector while the RET button at the lensis held down.To enable this capability, select CAM RET for the menuoption RET SW. This option can be found in the MODE> screen, which is accessible from the CAMOPERATION page.Setting the Marker Displays# < VF MARKER >MKR:ATABLE :ACENTER MARK :1SAFETY ZONE :2SAFETY AREA :90%FRAME SIG :4:3FRAME MARK :OFFFLAME LVL :15Marker Check Screen Displays (MARKER SELECT button function)MARKER SELECT buttonCenterMarkersSafety zoneThe view angle specified through the menuoption FRAME SIG is displayed.Checking Return Video Signal in the Viewfinder< SW MODE ># RET SW :R.REVIEWS.BLK LVL :-10AUTO KNEE SW :ONSHD,ABB SW CTL :ONCOLOR BARS :SMPTES.GAIN OFF :L/M/HDS.GAIN OFF :DS.GAIND.ZOOMX2 :OND.ZOOMX3 :OND.ZOOMX4 :ONRC CHECK SW :R.REVIEW
