Panasonic AW-HE100E Operating Instructions Manual

Also see for AW-HE100E: Operating instructions

22 (E)ENGLISHWhat to do when encountering problems in the basic shooting operationsIf the trouble is not resolved by taking the action suggested below, refer to “Troubleshooting” (page 55).When performing the operations using theaccessory wireless remote controlThe unit does not move. Press the [CAM1], [CAM2], [CAM3] or [CAM4] button toselect the unit which is to be operated.If only one unit is being used, it is normally selected usingthe [CAM1] button. If the unit’s status display lamp is off or lights up orange, itmeans that the unit’s power is not on.Refer to “How to turn the power on and off” (page 15),and turn on the power. If the unit’s status display lamp does not blink evenwhen the wireless remote control is operated near theunit’s wireless remote control signal light-sensing area, itmeans that the wireless remote control’s batteries haverun down.Replace the batteries.Multiple colour bands (colour bars) aredisplayed.Press the [MODE] button to switch to the camera picture.The menu screen is displayed.Press the [MENU] button for two seconds to exit the menu.The lens focus is not adjusted automatically.Press the [A/FOCUS] button to switch to auto focusing.The camera picture is too light or too dark.1. Press the [A/IRIS] button to switch automatically to thelens iris adjustment.2. Press the [AUTO] button of [GAIN] to switch automaticallyto the gain adjustment.Something is wrong with the colouring of thecamera pictures.Refer to “Auto tracking white adjustment (ATW)” (page 31),and switch to “ATW”.When performing the operationsusing the controllerThe unit does not move. Select the unit to be operated by following the procedurebelow.When the AW-RP655 is connected:Press the [1], [2], [3], [4] or [5] button of [CONTROL/PREVIEW MONITOR OUT SEL].When the AW-RP555 is connected:Press the [1], [2], [3], [4] or [5] button of [CONTROL].When the AW-RP400/AW-CB400 is connected:Press the [1], [2], [3], [4] or [5] button of [CONTROLSELECT]. If the [OPERATE] lamp on the controller is off, it meansthat the power of the controller is not on. If the unit’s status display lamp is off or lights up orange,it means that the unit’s power is not on. Refer to “Howto turn the power on and off” (page 15), and turn on thepower.Multiple colour bands (colour bars) aredisplayed.Press the [MODE] button to switch to the camera picture.The menu screen is displayed.Press the [MENU] button to exit the menu.The lens focus is not adjusted automatically.Press the [EXT(AF)] button to switch to auto focusing.The camera picture is too light or too dark.1. Press the [IRIS] button several times to turn on its lamp,and switch the lens iris adjustment to auto.2. Press the [GAIN] button several times to turn on its lamp,and switch the gain adjustment to auto.When the AW-RP400 is connected, press the [AGC]button on the AW-CB400.Something is wrong with the colouring of thecamera pictures.Refer to “Auto tracking white adjustment (ATW)” (page 31),and switch to “ATW”.