Panasonic DIGA DMR-ES30V Operating Instructions Manual

Also see for Diga DMR-ES30V: Operating instructions Quick setup guide Operating instructions Operating instructions Operating manual

Contents

Playback48VQT0P03VHSVHS PlaybackThe surface on which you can see a roll of tape should face up,Insert a video cassette.≥The unit is automatically turned on.∫ To eject a video cassette≥You can eject a video cassette even when the unit is in standby mode. It switches back tostandby once it ejects the video cassette.For main unit≥Press [<, EJECT] on the main unit.For remote control≥Press [VHS] and then press and hold [∫, STOP] for about 3 or more seconds.≥Break off the video cassette’s tab to prevent accidental erasure. Cover the hole with a double layer ofadhesive tape when you want to use the video cassette for recording again.≥You can use video cassettes with the VHS and S-VHS marks, but the unit is unable to make full use ofthe characteristics of S-VHS video cassettes.≥Poor quality or damaged video cassettes can cause the heads to become dirty and malfunction. Store your video cassettes carefully anddiscard them when they become dirty or damaged.≥Never use video cassettes on which liquids have been spilled or those that are extremely damaged since this will not only cause the headsto become dirty, but will also make the unit malfunction.Cleaning the video headsDirt on the video heads can cause poor recording and play.If this happens, insert and eject a cassette 5–10 times successively to remove the dirt from the video heads. If the problem persists, seekadvice from a qualified service person.The tuning on DVD is automatically applied to the one on VHS. Therefore, tuning on VHS is not required.When only the video output on VHS does not look natural, use the Fine Tuning function on VHS as below.You can finely tune the reception on VHS regardless of the receptionon DVD.[1] Press [ENTER] for about 5 seconds or more.≥Tuning screen appears.[2] Press [3, 4, 2, 1] to select the desiredchannel name, and then press [ENTER].≥Fine Tuning screen appears.[3] Press [2, 1] to obtain the best tuningcondition.≥Press [ENTER] to select “AUTO”.[4] Press [RETURN] to start the new condition.≥To continue Fine Tuning:Repeat steps 2–4.∫To exit the tuning screenPress [RETURN].Note≥When you wish to set the item other than Fine Tuning, set it onDVD. (l 44)≥When you set or change the Tuning menu in SETUP menu onDVD, the settings on the Fine Tuning is restored to the default.Inserting a video cassetteVideo cassette information∫ Video cassettes∫ Video cassette care∫ MaintenanceHead cleaning by service agents is not covered by warranty.Setting Up∫ Fine TuningTabPreparation≥Select the unit viewing channel (e.g. AV input) on the TV.≥Press [VHS].≥Press [Í, DVD/VHS] to turn the unit on.Tuning: accessENTER: returnRETURN: select1 01 6 - - - - -2 02 7 - - - - -3 03 8 - - - - -4 04 9 - - - - -5 05 10 - - - - -Pos Name Pos Name: autoENTER: returnRETURN: selectPos : 1Name : 01Channel : 4Fine tuning : AUTOMono : OFF