Panasonic DVCPRO HD AJ-HD1800P Operating Instructions Manual

Also see for DVCPRO HD AJ-HD1800E: Parts list

Contents

Panasonic DVCPRO HD AJ-HD1800P Operating Instructions Manual Manual pdf 124 page image

124Rack mountingThe unit can be mounted into a 19-inch standard rack if theoptional rack-mounting adapters (AJ-MA75P : option) areused. For the installation rails, it is recommended that the railand bracket for 18-inch length (part number C-300-S-118) ofChassis Trak be used.(The complete slide rail and bracket unit is not available fromPanasonic.)For further details, consult your dealer.1 Attach the inner members of the slide rails. Refer to thefigure below for the positions where they are screwedinto place.z The length of the screws used is subject to arestriction. Use screws which are less than 2/5 inch(10 mm) long.z Attach the inner member at the same symmetricalpositions on the left (L) side as well.z Fix the members in place using 3 screws on eachside (total: 6 screws).z The letters shown in the figure are not actually markedon the side panels.2 Attach the outer member brackets to the rack. Checkthat the height is the same for the left and right brackets.3 Remove the four screws at the front used to attach theleft and right side panels.4 Attach the AJ-MA75P rack-mounting adapters using thesame four screws.5 Remove the four rubber feet on the bottom panel of theVTR, and install the VTR in the rack.After the VTR has been installed, check that it movessmoothly along the rails.z Keep the temperature inside the rack to between 5xC and40xC (41xF and 104xF).z Bolt the rack securely to the floor so that it will not toppleover when the VTR is pulled out.A B C D E F G HPositions where the right (R) inner member is screwed into placeInner memberRack-mounting adaptersEIAJ standard rackFasten to rack with thefixing screws.