57Function menus(continued)Thisenablesconfirmationofinformationsuchasthewarning/hour-meter/UMID.Verification, deletion of the error log file, retention/call to theSD memory card can do with the SHIFT picture.Warning displayWhen a warning occurs in this VTR, the warning mark (W)blinks at the top left of the screen.If(WARN) is nowpressed, the details of the warning can be checked out onthe LCD monitor.When more than one warning has occurred, turn the ADJdial to scroll through the messages.Hour-meter displayWhen(HOURS) is pressed, the hour-meter informationcan be checked out on the LCD monitor.UMID displayPress(UMID) to confirm the current UMID informationfor the image on the LCD monitor.DIF Status displayPress(DIF1) or(DIF2) to display the different kindsof information about the current DIF (IEEE 1394 interface).Error log functionThe error log mode can be selected by pressing thebutton and switching the screen to .General descriptionWhen the following warnings have occurred while the tape isrunning, the warning messages, time codes and operatingmodes are saved, and a list of this information can be readout on the LCD monitor.Up to 99 warnings which haveoccurredcanbesaved.Ifthestoragecapacityof99warnings is exceeded, the processing that is conducted as aresult is based on the setup menu item No.015 (AUTOSTEP) setting.LCD monitor displaysOperation mode displayThis indicates the operation mode at the point when thewarning was saved.Warning displayThis indicates the warning message which is saved.Saved warning status displayThis indicates the number of the currently displayed warningwhich has been saved and the total number of warningswhich have been saved.Time code displayThis indicates the time code at the point when the warningwas saved.Cueing up the tape to the warning pointThewarninglistdisplayedontheLCDmonitorcanbescrolledbyturningtheADJdial.WhenthewarningoccurrencepointtobecheckedisselectedandthePREROLL button is pressed, the tape is cued up to theposition of the time code which has been saved.F1SHIFTF2F3F4F5F6Warning markF1F2F2DIAG-MENUUMID INFOMATNOCOPYOWNRJPN :ORG :USERJAN-28-0223:30:30 +03h00m±3775m3DE 180'00'00.0'N90'00'00.0'POSDATETIME00001234005678BA00B04582010000010F4F5DIAG-MENUDIF STATUS 1NODE CNTMY IDROOT IDIRM IDRCV IDGAP CNTEUI-6410000630080458200000000DIAG-MENUDIF STATUS 2FMTRATEN/PCHN63SPEEDSTATSTOPVIDEOAUDIOFMTRATEN/PCHNSPEEDSTARTVIDEOAUDIOHD1001XNTSC63400OKOKOKSHIFTF1SHIFTF2F3F4F5F6Warning messageswhich are savedDescription(Refer to page 129 and following.)NO RFA blank section on the tape lasting more than1 second has been detected. (During normalplayback)SV NOT LOCKEDThe servo has been disengaged for morethan 3 seconds. (During recording, normalplayback or editing)LOW RFAn envelope level which is about 1/3 of nor-mal or a CTL level which is about 1/6 of nor-mal has been detected for more than 1second. (During recording, normal playbackor editing)HIGH ERROR RATEThe error rate has deteriorated, and correc-tion or compensation has been applied to thevideo or audio playback signals. (During nor-mal playback)Operation mode displayTime codedisplayWarning displaySaved warning status display
