Panasonic DVCPRO HD AJ-HD1800P Operating Instructions Manual

Also see for DVCPRO HD AJ-HD1800E: Parts list

Contents

Panasonic DVCPRO HD AJ-HD1800P Operating Instructions Manual Manual pdf 28 page image

28Jog/ShuttleJog Mode1 Push in the search dial.Confirm that the JOG lamp lights.2 Turn the search dial.The dial’s click-stops are released, and the tape is playedback at the speed corresponding to the speed at whichthe dial is turned.The maximum jog speed can be changed by selectingthe setup menu item No.310 (JOG FWD MAX) andNo.311 (JOG REV MAX) settings.When the dial is no longer turned, a still picture willappear.3 To transfer the VTR from the jog mode to another mode,press the button that corresponds to the mode con-cerned.The default setting for the search dial is the direct searchmode for moving to the shuttle mode/jog mode/variablemode.It is possible to set the mode to the search mode only whenthe search button is pressed by changing the setting inSETUP MENU No. 100 (SEARCH ENA) to [KEY].Shuttle Mode1 Press the search dial to return the pressed dial to theoriginal position.The SHTL lamp lights, and the mode becomes theshuttle mode.z Immediately after turning on the power, turn the searchdial to the center position.2 Press the SHTL/SLOW button to shift to [SHTL] or[SLOW].3 Turn the search dial.z When the lamp lights for [SHTL] of JOG/SHTL/SLOW,the playback rate will vary within the range from 0 to +/-32 times. The range can be changed to +/-9.8, +/-16,and +/-32 times in SETUP MENU No. 101 (SHTLMAX). When the dial is at the center position, imagesbecome still pictures.z When the lamp lights for [SLOW] of JOG/SHTL/SLOW,the playback rate will vary within the range from -4.9 to+4.9 times. The maximum rate can be switched inSETUP MENU No. 308 (VAR FWD MAX) and No. 309(VAR REV MAX). However, noise may be generatedunless the rate is set within the range from -1.0 to +2.0times. For recording tapes other than the DVCPROHD-LP recording tape, noise may be generated unlessthe rate is set within the range from -1.0 to +1.1 times.When the dial is at the center position, images becomestill pictures.4 To move from the Shuttle mode to other modes, pressthe STOP button or other buttons.z From the audio monitor output, audio can be played backwhen the rate is within the range from -32 to +32 times.However, you must select [PCM] in SETUP MENU No.746 (MONI CH SEL).z Audio playback in search mode may contain some noise.