62To disconnect USB cable safelyIf USB cable is disconnected while computer is on, error dialog may appear.In such case click [OK] and close the dialog box. By following the steps belowyou can disconnect the cable safely.1 Double click the icon in task tray.≥Hardware disconnect dialog appears.2 Select [Panasonic DVC USB-SERIAL Driver] 1 and click[Stop].3 Verify [Panasonic DVC USB-SERIAL Driver] is selected andclick [OK].≥Click [OK], and you can safely disconnect the cable.Note on the driver name 1 displayedThe driver name displayed will differ depending on your OS, operatingenvironment and the mode of the Palmcorder.Windows XP/2000:(When the Palmcorder is in VCR mode or Camera Mode:)[Panasonic DVC USB-SERIAL Driver (COM 4)] (The numeral after “COM” willdiffer depending on the operating environment of your personal computer.)(When the Palmcorder is in Card Playback Mode:)[Panasonic DVC USB Driver] or [Panasonic DV DISK Port Driver]Windows Me:[Panasonic DVC Port Driver Version 2.0]≥Some OS, such as Windows 98SE, may not show the icon indicating thatyou may safely disconnect in task tray. (OS may be set not to show) Makesure Palmcorder’s [ACCESS] lamp is off and disconnect the cable..........................................................................................................................CAUTION:If you disconnect the USB Cable while the [ACCESS] Lamp is on, it maydamage the Card data..........................................................................................................................~~~~~~~~~~~~~~~~~~~~~~~~If you no longer need software or driver(Uninstall)The screens may vary with the type of the OS. (In this manual, explanation isoffered with Windows Me screen.)1 Select [Start] (>> [Settings]) >> [Control Panel], select thesoftware or the driver from [Add/Remove Programs] touninstall.≥Uninstalling steps may vary depending on the OS. Please refer to the usermanual of your OS.≥If you install the USB Driver while the USB Connecting Cable is beingconnected, or if you don’t follow these Operating Instructions, thePalmcorder will not be recognized correctly. In this case, delete the USBDriver from [Device Manager] as described below, uninstall the USB Driver,and re-install it.1 Set the Palmcorder to VCR Mode or Camera Mode, connect it to thepersonal computer, and delete [Panasonic DVC USB-SERIAL Driver(COM X)] (or [Panasonic Serial USB Driver]) from [Device Manager].2 Set the Palmcorder to Card Playback Mode and delete [Panasonic DVCUSB Driver] (or [Panasonic DVC USB Driver Version 2.0]) (If you useWindows Me/98SE, also delete [Panasonic DVC Port Driver Version2.0]).12311
