34VQT1G66SetupQuick startWhen quick start is ON the battery power is stillbeing consumed, even when the LCD monitorand the viewfinder are closed.This unit will resume recording/pause modeabout 1.7 seconds after the LCD monitor and theviewfinder are reopened.≥ When in quick start standby mode, about70% of the power used in recording pausemode is being consumed so the recordingtime will be reduced.≥ This is only activated in the following case.sWhen the mode dial is set to and anSD card is inserted.1 Press the MENU button, thenselect [SETUP] #[QUICK START] # [ON] andpress the cursor button.2 Close the LCD monitor andretract the viewfinder while themode dial is set to .The status indicator A flashes green and the unitgoes into quick start standby mode.≥ The lens cover does not close.3 Open the LCD monitor or extendthe viewfinder.The status indicator A lights red and the unit isput into recording pause approx. 1.7 secondsafter it is turned on.ª To cancel Quick startPress the MENU button, then select [SETUP]# [QUICK START] # [OFF] and press thecursor button.≥ The status indicator goes off, the lens covercloses and the power turns off if the mode dialis set to OFF while the unit is in quick startstandby mode.≥ The status indicator goes off and the powerturns off if quick start standby mode continuesfor approx. 5 minutes.≥ Quick start standby mode is cancelled, thestatus indicator goes off and the power turnsoff in the following cases.jthe mode dial is switchedjthe battery is removed or the AC adaptor isdisconnected≥ When this unit is quick-started with the whitebalance on automatic, it may take some timeuntil the white balance is adjusted if the scenebeing recorded has a light source differentfrom the scene last recorded. (When the colournight view function is used, however, the whitebalance of the scene last recorded is retained.)≥ When this unit is quick-started, the zoommagnification becomes 1k and the picture sizemay differ from what it was before quick startstandby mode.≥ If [POWER SAVE] (l 132) is set to[5 MINUTES] and the unit automatically goesinto quick start standby mode, close the LCDmonitor and then open it again.MENU
