System Programming 4-514.3 System ProgrammingVM Status DTMF Set113Description Sets the DTMF signals (“inband”) that are transmitted to the VoiceProcessing System (VPS), by the Panasonic telephone system,under all the dial and connect events which the VPS can occur.The following signals are sent to the VPS with the assigned DTMFsignals:RBT (ringback tone) : This signal is sent when calling anextension.BT (busy tone) : This is sent when the called extension isbusy.ROT (reorder tone) : This is sent when the dialled number isinvalid.DND (DND tone) : This is sent when the other extension hasDND assigned.Answer : This is sent when the other extensionanswers the call.Disconnect : This is sent when the other extensionhangs up.Confirm (confirmation tone) :This is sent when the feature number for“Message Waiting Lamp” is valid.FWD VM RBT (FWD to VM ringback tone) :Not available (reserved).FWD VM BT (FWD to VM busy tone) :This is sent when the called extensionhas set Call Forwarding to VPS.FWD EXT RBT (FWD to extension ringback tone) :Not available (reserved).Selection • RBT / BT / ROT / DND / Answer / Disconnect / Confirm /FWD VM RBT / FWD VM BT / FWD EXT RBT• DTMF signal number: 3 digits (max.)Default RBT – 1; BT – 2; ROT – 3; DND – 4; Answer – 5; Disconnect – #9Confirm – 9; FWD VM RBT – 6; FWD VM BT – 7; FWD EXTRBT – 8Programming 1. Enter 113.Display: VM Status Set2. Press NEXT to program ringback tone status.To program another status, keep pressing NEXT until the desiredstatus is displayed.Display example: RBT :1
