4.8 Extension ProgrammingExtension Group Assignment6024-128 System ProgrammingDescription Assigns each extension to an extension group. Extension groupsare used for Group Call Pickup and Paging – Group.Selection • Jack number: KX-TD816 – 01 through 16, (-1 / -2)KX-TD1232 – 01 through 64, (-1 / -2)( =all jacks, -1 = first part, -2 = second part)• Extension group number: 01 through 16, ( =all groups)• Disable (not belong) / Enable (belong)Default All jacks-1/2 – Extension group 1:EnableProgramming 1. Enter 602.Display: EXT Group Asn2. Press NEXT.Display: Jack NO?→3. Enter a jack number.To enter jack number 01, you can also press NEXT.To select the second part (-2), press NEXT after entering the jack number.Display example: #01-1:EG01:Enabl4. Enter the extension group number.You can also keep pressing or until the desired extensiongroup number is displayed.5. Keep pressing SELECT until the desired selection isdisplayed.6. Press STORE.7. To program another jack, press NEXT or PREV, orSELECT and the desired jack number.8. Repeat steps 4 through 7.9. Press END.Conditions • There is a maximum of sixteen extension groups. Each extension canbelong to more than one group.• For the KX-TD1232, jack numbers 01 through 32 are for the MasterSystem and 33 through 64 are for the Slave, if available.• For an explanation of jack numbering, see “Rotation of jack number”on page 4-7 of the Installation manual.• To assign all jacks to one extension group, press the key in step 3.In this case, the display shows the contents programmed for Jack 01.Feature References Section 3, Features,Call Pickup, Group Extension GroupPaging – Group
