4.10 Resource ProgrammingSMDR Format8014-158 System ProgrammingDescription Used to match the SMDR output to the paper size being used in theprinter. Page length determines the number of lines per page. Skipperforation determines the number of lines to be skipped at the end ofevery page. Page width determines the number of characters per line.Selection • Page length (lines): 4 through 99• Skip perforation (lines): 0 through 95• Page width (characters): 80 / 100Default Page length – 66; Skip perforation – 0; Page width – 80Programming 1. Enter 801.Display: SMDR Format2. Press NEXT to program page length.Display example: Page Length:663. Enter the page length.To change the current entry, press CLEAR and the new page length.4. Press STORE.5. Press NEXT to program skip perforation.Display example: Skip Perf: 06. Enter the skip perforation.To change the current entry, press CLEAR and the new skip perforation.7. Press STORE.8. Press NEXT to program page width.Display example: Page Width: 809. Keep pressing SELECT until the desired selection isdisplayed.10. Press STORE.11. Press END.Conditions • The page length should be four lines or more longer than the skipperforation length.• If 80 characters for page width is selected, the last five digits of accountcodes are not printed out.• A title is positioned on the first three lines on every page.• The programmed format becomes valid only if the EIA (RS-232C)cable is connected. If a printer is already connected, disconnect it andconnect again. Otherwise the former format becomes valid.Feature References Section 3, Features,Station Message Detail Recording (SMDR)
