4.6 CO Line ProgrammingPulse Speed Selection403System Programming 4-91Description A CO line set for pulse or call blocking mode in program [402]“Dial Mode Selection” can have two pulse rates, 10 pps (low) and20 pps (high). This program sets the pulse speed for each CO lineset to pulse or call blocking mode.Selection • CO line number:KX-TD816 – 01 through 08, ( =all CO lines)KX-TD1232 – 01 through 24, ( =all CO lines)• 10 pps / 20 ppsDefault All CO lines – 10 ppsProgramming 1. Enter 403.Display: Pulse Speed2. Press NEXT.Display: CO Line NO?–>3. Enter a CO line number.To enter CO line number 01, you can also press NEXT.Display example: CO01:10pps4. Keep pressing SELECT until the desired selection isdisplayed.5. Press STORE.6. To program another CO line, press NEXT or PREV, orSELECT and the desired CO line number.7. Repeat steps 4 through 6.8. Press END.Conditions • In the case of KX-TD1232, CO01 through CO12 are for the MasterSystem and CO13 through CO24 are for the Slave, if available.• To assign all CO lines to one selection, press the key at step 3. Inthis case, the display shows the contents programmed for CO01.• The pulse speed required is determined by the CO or PBX line.• Program [990] “System Additional Information, Area 02 - Bit 07, 11and 12” are used to select a pulse break ratio and inter-digit pause, ifneeded.Feature References Section 3, Features,Dial Type Selection
