Panasonic KX-TG1061C Operating Instructions Manual

Useful Information40Error messagesIf the unit detects a problem, one of the following messages is shown on the display.Display message Cause/solutionBusy L The called unit is in use.L Other units are in use and the system is busy. Try againlater.L The handset you are using is too far from the base unit.Move closer and try again.L The handset’s registration may have been cancelled. Re-register the handset (page 27).Check tel line L The supplied telephone line cord has not been connectedyet or not connected properly. Check the connections(page 8).Error!! L Recording was too short. Try again.Failed L Phonebook copy failed (page 19). Confirm the other unit(the receiver) is in standby mode and try again.Incomplete L Phonebook copy is incomplete. The receiver’s phonebookmemory is full. Erase the unnecessary phonebook entries(page 17) from the other unit (the receiver) and try again.Memory full L The phonebook memory is full. Erase unnecessaryentries (page 17).L Message memory is full. Erase unnecessary messages(page 31, 32).Messages full L Message memory is full. Erase unnecessary messages(page 31, 32).No link. Reconnect base ACadaptor.L The handset has lost communication with the base unit.Move closer to the base unit and try again.L Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.L The handset’s registration may have been cancelled. Re-register the handset (page 27).Requires subscription toCaller ID.L You must subscribe to a Call Display service. Once youreceive caller information after subscribing to a CallDisplay service, this message will not be displayed.Use rechargeable battery. L A wrong type of battery such as Alkaline or Manganesewas inserted. Use only the rechargeable Ni-MH batteriesnoted on page 4, 5.TG106xC(e).book Page 40 Wednesday, February 25, 2009 11:13 AM