Panasonic KX-TG1061C Operating Instructions Manual

Useful Information42Making/answering calls, intercomCall DisplayI fully charged the batteries, but )still flashes or 0 is displayed.L Clean the charge contacts and charge again (page 9).L It is time to replace the batteries (page 8).I fully charged the batteries, butthe operating time seems to beshorter.L Clean the battery ends (S, T) and the charge contacts with adry cloth and charge again.Problem Cause/solutionw is flashing. L The handset is too far from the base unit. Move closer.L The base unit’s AC adaptor is not properly connected.Reconnect AC adaptor to the base unit.L You are using the base unit or handset in an area with highelectrical interference. Re-position the base unit and use thehandset away from sources of interference.L The handset is not registered to the base unit. Register it (page27).Noise is heard, sound cuts in andout.L You are using the base unit or handset in an area with highelectrical interference. Re-position the base unit and use thehandset away from sources of interference.L Move closer to the base unit.L If you use a DSL/ADSL service, we recommend connecting aDSL/ADSL filter between the base unit and the telephone linejack. Contact your DSL/ADSL provider for details.The base unit and/or handsetdoes not ring.L The ringer volume is turned off. Adjust the ringer volume (page14).L Night mode is turned on. Turn it off (page 25).I cannot make a call. L The dialing mode may be set incorrectly. Change the setting(page 12).L The handset is too far from the base unit. Move closer and tryagain.I cannot make long distance calls. L Make sure that you have long distance service.Problem Cause/solutionCaller information is notdisplayed.L You must subscribe to Call Display service. Contact yourservice provider/telephone company for details.L If your unit is connected to any additional telephone equipmentsuch as a Call Display box or cordless telephone line jack, plugthe unit directly into the wall jack.L If you use a DSL/ADSL service, we recommend connecting aDSL/ADSL filter between the base unit and the telephone linejack. Contact your DSL/ADSL provider for details.L The name display service may not be available in some areas.Contact your service provider/telephone company for details.L Other telephone equipment may be interfering with this unit.Disconnect the other equipment and try again.Problem Cause/solutionTG106xC(e).book Page 42 Wednesday, February 25, 2009 11:13 AM