- 9 -- 8 -Safety precaution labelis affixed to the product.Connector for motor cable andCS signal cableGround terminal Oil sealOutput shaftSafety precaution labelis affixed to the product.O-ring (not provided on a round shaft model)Motor nameplateBracket BFrame[Front view] [Side view]Connector formotor connection(MOTOR)Power LED(green: when power is ON)Alarm LED(red: when Trip is operation )Connector forcommunications(SER)Connector for power input(POWER)Connector for control signals(I/O)Attachment holeGrounding terminal screwName of partBrushless motorBrushless amplifierName of part InstallationInstall the brushless motor and brushless amplifier properly for preventing failureand accident.Transport• Use caution enough in transporting the unit to prevent injury by drop or fall, and avoiddamage to the equipment.Storage• Keep the unit indoors in a clean and dry place free from vibration with little change oftemperature.• In keeping a gear head alone, direct the output shaft down.(Otherwise, grease leaking is possible.)Location• Location gives great influence upon the life of brushless motor and brushless amplifier,therefore choose a place in conformance with the conditions below:(1) Indoors where the motor is not subjected to rain water and direct sun beam.(2) Do not use the motor in corrosive atmosphere such as hydrogen sulfide, sulfurousacid, chlorine, ammonia, sulfur, gas chloride, gas sulfide, acid, alkali, and salt, in theatmosphere of combustible gas, or in the vicinity of flammables.(3) Place not exposed to grinding liquid, oil mist, iron powder, and cutting particle.(4) Well-ventilated place with little moisture, oil, or inundation, and place far from heatsource such as a furnace.(5) Place easy to check and clean(6) Place free from vibration(7) Do not use the unit in an enclosed environment. Enclosing may raise the temperatureof motor (amplifier), and shorten their life.Caution in installing gear headInstall a device that will ensure safety operation of the system even if the followingfailures should occur on the life end of gear head: idling by damaged teeth, lockingby bite, grease leakage, and the like.• As for application such as on a lifter or the like device, install a device for preventing dropby damaged teeth.• As for application such as opening and closing of door, install a release device againstlocking by gear biting.• As for food or textile equipment, install an oil pan for measures against grease leakage.• Do not install an encoder, sensor, contact, etc., in the proximity of gear head. Orotherwise, protect such devices against grease leakage.• In order to prevent unexpected accident, be sure to perform daily check.