Panasonic NV-GS50EN Operating Instructions Manual

Also see for NV-GS50EN: Service manual Service manual Service manual

Contents

Others-119-ª To Display Date/TimeIndicationTo display Date/Time Indication, set theappropriate Date/Time in [DATE/TIME]on the [DISPLAY SETUP] Sub-Menu.(-78-)You can also press the [DATE/TIME]Button of the Remote Controllerrepeatedly to display or change theDate/Time Indication.ª To Change the Display ModeBy changing [DISPLAY] on the[DISPLAY SETUP] Sub-Menu, you canchange the Display Mode to All FunctionDisplay [ALL], Partial Display [PARTIAL]and Minimum Display [OFF]. (-78-)Owner IDYou can register your name and addressin your Movie Camera to identify theowner.1 Set [CAMERA FUNCTIONS] >>[OTHER FUNCTIONS1] >>[OWNER ID SET] >> [YES].≥The [OWNER ID] Menu appears.2 Turn the [PUSH] Dial (38) to select[PIN NUMBER] and press the[PUSH] Dial (38) to input desirednumbers.3 Turn the [PUSH] Dial (38) to selectnumbers and press the [PUSH] Dial(38) to enter them.≥Be sure to input 4 digits. Otherwisethe Pin Number will not beregistered.4 Press the [∫] Button.5 Repeat Steps 2–4 to input desiredcharacters for [NAME] and[POSTCODE].≥You can input up to 12 characters in[NAME], and up to 11 characters in[POSTCODE].6 Press the [∫] Button to finish thesetup.To Verify Owner IDKeep pressing the [;] Button forapproximately 5 seconds.To Correct the ContentsIf Owner ID has already been set,carrying out Step 1 will display [INPUTPIN NUMBER] on the screen. Input thePin Number you have already selected.If the number is not correct, the screenwill not change. If the number is correct,the contents of the setup will bedisplayed. (By repeating Steps 2 to 4,you can change the contents.)Initializing the ModesYou can change the Menu settings backto the shipping condition.1 Set [CAMERA FUNCTIONS] >>[OTHER FUNCTIONS2] >>[INITIAL SET] >> [YES].≥The initializing takes for a while.≥After the initializing is completed, the[COMPLETED] Indication appearswith beeps.≥Initializing will not erase the Owner IDsetting and the clock setting (-80-) thathas been adjusted.Warning/Alarm IndicationsIf any one of the following indicationslights up or flashes, please check thecondition of the Movie Camera.3: Condensation has occurred. -130-Y: The accidental erasure preventionslider on the inserted Cassette isopen (that is, set to [SAVE]).You are about to do audio dubbingon the unrecorded (blank) portionof the tape.No Cassette is inserted. -74-6: The Battery is low. Recharge it. -72-0: The built-in battery is low. -80-:: The video heads are dirty. -130-2END:The tape came to end duringrecording.REMOTE:Wrong Remote Controller Modehas been selected. -71-UNPLAYABLE TAPE(OTHER FORMAT):You are attempting to play back atape section that has beenrecorded with a different TVsystem.UNABLE TO A. DUB(LP RECORDED):Because the original recording wasdone in LP Mode, audio dubbingcannot be performed.INCOMPATIBLE TAPE:This Cassette is incompatible.PLEASE RE-OPERATEAFTER PUSHINGRESET BUTTON:Mechanism Irregular is detected.Press the [RESET] Button (-69-).This may solve the problem.