[NETWORK] menuOn the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.Refer to "Navigating through the menu" (Æpage 45) for the operation of the menu screen.After selecting the item, pressf asqw to set.[WIRED LAN]You can make detailed wired LAN settings.Press1) as to select [WIRED LAN].Press the button.2)The [WIRED DETAILED SETUP] screen is displayed.fPress3) as to select an item, and change the setting according to the instructions.[DHCP][ON]: If a DHCP server exists in the network to which the projector is connected,the IP address will automatically be acquired.[OFF]: If a DHCP server does not exist in the network to which the projector isconnected, additionally set [IP ADDRESS], [SUBNET MASK] and[DEFAULT GATEWAY].[IP ADDRESS] Enter the IP address if DHCP server is not used.[SUBNET MASK] If not using a DHCP server, enter the subnet mask.[DEFAULT GATEWAY] Enter the gateway address if DHCP server is not used.[DNS1] Enter the DNS server address if DHCP server is not used.[DNS2] Enter the alternate DNS server address if DHCP server is not used.Press4) as to select [OK], and press the button.Default wired LAN settingsrThe following settings are set before the projector leaves the factory.f[DHCP] OFF[IP ADDRESS] 192.168.10.100[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.10.1[DNS1] / [DNS2] NONENoteWhen using a DHCP server, confirm that the DHCP server is running.fConsult your network administrator regarding the IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.f76 - ENGLISHChapter 4 Settings - [NETWORK] menu
