FCC NOTICE (USA AND CANADA)This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation of this device.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range.FCC and IC require this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce thepotential for harmful interference to co-channel Mobile Satellite systems. High power radars are allocatedas primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can causeinterference with and/or damage this product.The available scientific evidence does not show that any health problems are associated with using low powerwireless devices.There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wirelessdevices emit low levels of radio frequency energy (RF) in the microwave range while being used.Whereas high levels of RF can produce health effects (by heating tissue), exposure to low-level RF that doesnot produce heating effects causes no known adverse health effects.Many studies of low-level RF exposures have not found any biological effects. Some studies have suggestedthat some biological effects might occur, but such findings have not been confirmed by additional research.Wireless LAN adaptor has been tested and found to comply with FCC/IC radiation exposure limits set forth foran uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C toOET65 and RSS-102 of the IC radio frequency (RF) Exposure rules.NOTIFICATION (Canada)This class B digital apparatus complies with Canadian ICES-003.Product Identification Marking is located on the bottom of the Wireless LAN Adaptor.Federal Communication Commission (FCC) / IC Radiation Exposure StatementThis EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999/IC RSS-102 and had been tested in accordance with the measurement methods and procedures specifiedin OET Bulletin 65 Supplement C/IEEE 1528. This equipment should be installed and operated with minimumdistance 0.5 cm between the radiator & your body.CAUTION:Be aware of the following limits before using the Wireless LAN Module.• To use the Wireless LAN Module, an access point needs to be obtained.• Do not use the Wireless LAN Module to connect to any wireless network (SSID*) for which you do not haveusage rights. Such networks may be listed as a result of searches. However, using them may be regardedas illegal access.*SSID is a name for identifying a particular wireless network for transmission.• Do not subject the Wireless LAN Module to high temperatures, direct sunlight or moisture.• Do not bend, or subject the Wireless LAN Module to strong impacts.• Do not disassemble or alter the Wireless LAN Module in any way.• Do not attempt to install the Wireless LAN Module in any incompatible device.• Do not remove the Wireless LAN Module from the host product during operations.• Data transmitted and received over radio waves may be intercepted and monitored.• To avoid malfunctions caused by radio wave interface, keep the host product away from the devices such asother wireless LAN devices, microwaves and the devices that use 2.4 GHz and 5 GHz signals when usingthe Wireless LAN Module.• When noises occur due to the static electricity, etc., the host product might stop operating for the protectionof the devices. In this case, turn the host product Off with Mains power On / Off switch, then turn it On again.• Depending on the area, this Wireless LAN Module may not be available.Read this first!4 - ENGLISH