[LAMP POWER]Switch the brightness of the lamp according to the operating environment of the projector or the purpose.1) Press as to select [LAMP POWER].2) Press qw to switch the item.f The items will switch each time you press the button.[NORMAL] Select when high luminance is required.[ECO1] Select when high luminance is not required.[ECO2] Select when lower luminance than [ECO1] is required.Notef Set it to [ECO1] rather than [NORMAL] when you want to reduce power consumption, extend the life of lamp and reduceoperation noise.f Set it to [ECO2] rather than [ECO1] when you want to reduce power consumption and extend the life of lamp.[ECO MANAGEMENT]This function optimizes lamp power according to the operating status to reduce power consumption.1) Press as to select [ECO MANAGEMENT].2) Press the button.f The [ECO MANAGEMENT] screen is displayed.3) Press as to select one item.Setting [AUTO POWER SAVE] in step 3)Set whether or not to enable the three functions, [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTEDETECTION].Notef [AUTO POWER SAVE] cannot be set when the [LAMP POWER] is set to [ECO2].4) Press qw to switch the [AUTO POWER SAVE].[ON] Enables power-saving mode.[OFF] Disables power-saving mode.5) Press as to select one item.[AMBIENT LIGHT DETECTION] Adjusts the lamp power according to the ambient brightness.[SIGNAL DETECTION] Drops the lamp power when no signal is input.[AV MUTE DETECTION] Drops the lamp power in the AV mute mode.6) Press qw to switch the item.f The items will switch each time you press the button.[ON] Enables above setting.[OFF] Disables above setting.Notef Lamp power cannot reduced automatically in the following cases:- When [LAMP POWER] is set to [ECO2].- When the lamp lit or the setting of [LAMP POWER] is completed, etc..f When [AUTO POWER SAVE] is set to [OFF], [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTEDETECTION] cannot be set.f [AMBIENT LIGHT DETECTION] will not work correctly when placing some objects on the ambient luminance sensor.Setting [POWER MANAGEMENT] in step 3)Set the operation as following if there is no signal input.1) Press as to select [POWER MANAGEMENT].2) Press qw to switch the item.f The items will switch each time you press the button.76 - ENGLISHChapter 4 Settings - [PROJECTOR SETUP] menu