Connecting with Wired LANProjector settings1) Use the LAN cable (Straight) to connect the projector with computer.2) Turn on the projector.3) Press the press button.4) Set the detailed setup of [WIRED LAN].For details, see “WIRED LAN” (Æpage 85).Notef Please confirm with your network administrator before you connect to an existing network.f The following settings are set before the projector leaves the factory.[DHCP] OFF[IP ADDRESS] 192.168.10.100[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.10.1[DNS1]/[DNS2] NONEComputer operationConnection can be made with wired LAN. However, confirm to your system administrator on network settings before chang-ing any settings.1) Turn on the computer.2) Make the network setting according to your system administrator.f If the projector settings are the default settings (Æpage 85), the computer can be used with the following networksettings.[IP ADDRESS] 192.168.10.101[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.10.1Connecting with Wireless LANProjector settings1) Turn on the projector.2) Press the [USER1] ~ [USER3] for [WIRELESS LAN].3) According to the network number selected in step 2, set the detailed setup of [WIRELESS DETAILEDSETUP].f For details, see “WIRELESS DETAILED SETUP” (Æpage 86-88).Notef Wireless LAN and wired LAN cannot be used in the same segment.f When multiple devices are connected, a unique IP ADDRESS must be allocated to each device.f SSID has to be entered in alphanumeric letters.f You cannot set “any” or “ANY” for SSID.f The projector settings are not required when Miracast is connected. For details about Miracast, please refer topage 113.f The following settings are set before the projector leaves the factory.[M-DIRECT][IP ADDRESS] 192.168.12.100[SUBNET MASK] 255.255.255.0[SSID] M-DIRECT + The last 4 digits of the projector ID[CHANNEL] 1[KEY] The same string as the SSIDENGLISH - 93Chapter 4 Settings - [NETWORK/USB] menu