Setting54 - ENGLISHSettingsLogo PIN code changeJLogo PIN code can be changed to your desired four-digit number.Press ▲▼ to select [Logo PIN code1 )change] and press the button.Current logo PIN code dialog box appears.zPress ▲▼ to enter the current code,2 )press the ► button to fix the numberand move the red frame pointer to thenext box.The New Logo PIN code input dialog boxzappears.Repeat this step to set the new Logo3 )PIN code.AttentionBe sure to note the new Logo PIN code and keep it onzhand. If you lost the number, you could no longer changethe Logo PIN code setting.HDMI setupThis function is only used for HDMI input source.Press ▲▼ to select [HDMI setup].1 )Press ► or the button.2 ) The names for the output setting of Digital R/G/zB vary from equipment to equipment.ImageJNormal When the output of Digital R/G/Bequipment is set to Standard.Enhanced When the output of Digital R/G/Bequipment is set to Enhanced.SoundJHDMI When Digital input source is input,Sound is set to HDMI.Computer2When DVI input source is changedto HDMI input source, Sound is setto Computer 2.AttentionFor details, refer to the operating instructions of yourzDigital R/G/B equipment.Connect the computer 2 audio input signals tozCOMPUTER AUDIO IN 1 terminal as Sound function isset to Computer 2 and MIC function is turned on.TerminalThe COMPUTER 2 IN/MONITOR OUT terminal onthe back of the projector is switchable for computer 2input or monitor output.Press ▲▼ to select [Terminal] and1 )then press the button.Press ▲▼ to switch the item.2 )Computer 2 Computer inputMonitor out Monitor outNoteTerminal function is not available when selectingz[Computer 2] to the input source. Change the inputsource to the others (HDMI, Computer 1, Video orS-Video) so that the Terminal function will be available.Power managementFor reducing power consumption as well asmaintaining the lamp life, the Power managementfunction turns off the projection lamp when theprojector is not operated for a certain period.Press ▲▼ to select [Power1 )management].Press ► or the button to2 )access the submenu.ModeJPress ▲▼ and then press the1 ) button to select one modeamong the items as below.Ready When the lamp has been fully cooleddown, the indicator changes to green blinking.In this condition, the projection lampwill be turned on if the input signalis reconnected or any button on thecontrol panel or remote control ispressed.ShutdownWhen the lamp has been fully cooleddown, the power will be turned off.Off [Power management] function is off.TimerJPress ▲▼ to select [Timer] and then1 )press the button.Press ▲▼ to set the Timer(1~30min).2 )
