|
SettingENGLISH - 55 SettingsDirect onPress ▲▼ to select [Direct on] and1 )then press the button.Press ▲▼ to switch between [On] and2 )[Off].When this function is set to [On], the projectorzwill be automatically turned on just byconnecting the AC power cord to a wall outlet.Be sure to turn off the projector properly. If thezprojector is turned off in the incorrect sequence,the [Direct On] function does not work properly.Standby modeThis function can set the electric power when theprojector is standing by.Press ▲▼ to select [Standby mode]1 )and then press the button.Press ▲▼ to switch between the items2 )as below.EcoRestricts some functions instandby mode to reduce powerconsumption.Network Does not restrict functionalityeven in standby mode.NoteWhen selecting [Network], the cooling fans may bezrunning depending on the temperature inside theprojector even if the projector is turned off.If Standby mode is set to [Eco], you cannot use networkzfunctions when the projector is standing by. Also, youcannot use some RS-232C protocol commands.If set to [Network], you can use network functions whenzthe projector is standing by.P-timerThis function allows you to change the setting of theP-timer and execute it.Press ▲▼ to select [P-timer].1 )Press ► or button to access2 )the submenu.ModeJPress ▲▼ button to select one mode1 )among the items as below.Count upThe P-timer display 000:00appears on the screen and thecount up starts (000:00-180:00).Count down The time set in the Timer settingappears on the screen and thecountdown starts.TimerJPress ▲▼ to select [Timer] and then1 )press the button.Press▲▼ to set the [Timer](1-180 Min).2 ) Timer is available in [Count down] only. Factoryzdefault value is 10 Min.ExecuteJPress ▲▼ to select one among the1 )items as below and then press the button.Start It executes the count up or countdown function.*1Reset Reset the P-timer values.*2Exit To exit the P-timer operation.Press the button at Start and the*1 :indication changes into Stop. To stop Count up orCount down, press the button at Stopon the screen menu, then the indication changesinto Restart. Press the button atRestart to resume Count up or Count down.Press the button at Reset to return to*2 :the following value:Count up "000:00"Count down Timer that you setAttentionTo stop the [P-timer] function, press the zbutton.To cancel the [P-timer], press and hold the zbutton for a few seconds.
|
