Panasonic PT-VW430U Operating Instructions Manual

Also see for PT-VW430E: Service manual

Contents

Panasonic PT-VW430U Operating Instructions Manual Manual pdf 81 page image

ReplacementENGLISH - 81 MaintenanceJ Replacing the Lamp unitCAUTION:When the projector is mounted on a ceiling, do not work with your face close to the projector.zAttach the lamp unit and the lamp cover securely.zWhen you experience difficulty in installing the lamp, remove it and try again. If you use force to install thezlamp, the connector may be damaged.Turn off the Power by following the procedure1 )in “Turning off the projector” (Æpage 30).Unplug the AC power cord. Wait at least 1hour and make sure the lamp unit andsurroundings are cool.Use a Phillips screwdriver to loosen the2 )lamp cover fixing screw and remove thelamp cover.Remove the lamp cover by pulling it slowly towardzthe direction of the arrow.Use a Phillips screwdriver to loosen the3 )three lamp unit fixing screws until thescrews turn freely. Hold the used lampunit by its handles, and pull it gently fromthe projector.Insert the new lamp unit in correct4 )direction. Tighten the three lamp unitfixing screws securely with a PhillipsscrewdriverAttach the lamp cover, and tighten the5 )lamp cover fixing screw securely with aPhillips screwdriver.Attach the lamp cover by pushing it slowly oppositezthe direction of the arrow.NoteWhen you replace the new lamp unit (ET-LAV200), the projector resets the total usage time of the lamp unit automatically.zLamp coverLamp coverfixing screwLamp unit fixing screwsLamp unitLamp unit