Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual

Contents

Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual Manual pdf 11 page image

111321ZOOMINDEX INDEXSELECTSTORESTOPK L∫OSDCOUNTERV/REWSTILL ADVOFF/ONP.B.DIGITALDATE/TIMERESET TITLETWsVOLr¥RECMULTI/P-IN-PPHOTOSHOTSTART/STOPA.DUBPLAYPAUSEFF/WSTILL ADVMENUITEMSET6 1 5;E DVAR.SEARCH P.B.ZOOM12 115˚15˚15˚15˚ª Inserting a Button-type BatteryBefore using the remote controller, insert the supplied button-type battery.1 While pressing the Stopper 1, pull out the Battery Holder.2 Insert the button-type battery with the imprint (i) facingupward.3 Insert the Battery Holder into the Remote Controller.≥When the button-type battery becomes weak, replace it with a new CR2025battery. (A battery is normally expected to last about one year. However, itdepends on operation frequency.)≥Be sure to match the poles properly when inserting the battery.....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................WarningDanger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type recommended by theequipment manufacturer. Discard used batteries according tomanufacturer’s instructions.Risk of fire, explosion and burns. Do not recharge, disassemble, heatabove 212° F (100° C) or incinerate. Keep the Button-Type battery out ofthe reach of children. Never put Button-Type battery in mouth. Ifswallowed, call your doctor.....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................Replace battery with Panasonic PART NO. VSBW0004 (CR2025) only.Use of another battery may present a risk of fire or explosion.Caution: Battery may explode if mistreated.Dispose of used battery promptly. Keep away from children.Do not recharge, disassemble or dispose of in fire.~~~~~~~~~~~~~~~~~~~~~~~~~ª Using the Remote Controller1 Direct the Remote Controller at the Remote Control Sensoron the Palmcorder and press the desired button.≥Distance from the Palmcorder: Within approximately 15 feet (5 meters)≥Angle: Approximately 15 degrees in the vertical and horizontaldirections from the central axis≥The above operating ranges are for indoor use. Outdoors, or under stronglight, the equipment may not operate properly even within the aboveranges.≥Within 3 feet (1 meter) range, you can also use the Remote Controller onthe side (the LCD Monitor side) of the Palmcorder.Selecting Remote Controller ModesWhen two Palmcorders are used simultaneously, they can be operatedindividually by selecting different Remote Controller Modes.≥If the Remote Controller Mode on the Palmcorder and Remote Controller donot match, [REMOTE] is displayed.Setting on the Palmcorder:Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desiredRemote Controller Mode.Setting on the Remote Controller:[VCR1]: Press the [D] Button and [∫] Button simultaneously. 1[VCR2]: Press the [E] Button and [∫] Button simultaneously. 2≥When the battery in the Remote Controller is replaced, the Mode isautomatically reset to [VCR1] Mode.