Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual

Contents

Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual Manual pdf 66 page image

66ª CondensationIf excessive moisture condenses in the unit,[DEW DETECTED] Indication will flash, and the Palmcorderwill automatically turn off after about 1 minute.If this happens, follow the steps below:1 Take out the Cassette.≥None of the other functions operate. Depending on theamount of condensation, removing the Cassette maybecome difficult. If this happens, wait for 2 to 3 hoursbefore taking the Cassette out.2 Open the Cassette Compartment and wait for2 to 3 hours.≥The number of hours you should wait depends on theamount of condensation and ambient temperature.3 2 to 3 hours later, turn on the Palmcorder andcheck to see if the [DEW DETECTED]Indication is displayed.≥Even if the [DEW DETECTED] Indication is notdisplayed, as a precaution, please wait for anotherhour before using the Palmcorder.Watch for Condensation Even Before the[DEW DETECTED] Indication Is Displayed.≥Because condensation takes place gradually, the[DEW DETECTED] Indication may not be displayed duringthe first 10 to 15 minutes of condensation formation insidethe Palmcorder.≥In extremely cold places, condensation may freeze andform frost. In this case, the frost melts first, thus formingcondensation, and then it takes another 2 to 3 hours toeliminate the condensation.When the Lens Is Fogged:Set the [OFF/ON/MODE] Switch to [OFF] and leave thePalmcorder in this condition for about 1 hour. When the lenstemperature becomes close to the ambient temperature, thefog disappears naturally.ª Digital Video Head CleanerIf the heads (the parts that make contact with tape) are dirty,mosaic-like noise patterns may appear on the playbackimage, or the screen as a whole becomes black. If the headsare extremely dirty, recording performance deteriorates, and,in the worst case, the Palmcorder cannot record at all.Causes of Digital Video Heads Becoming Dirty≥Large quantity of dust in the air≥High-temperature and high-humidity environment≥Damaged tape≥Long operating hoursUsing Mini-DV Format Digital Video Head Cleaner1 Insert the Head Cleaner into the Palmcorder inthe same manner as a Video Cassette.2 Press the [1] Button, and 20 seconds later,Press the [∫] Button. (Do not rewind the tape.)3 Take out the head cleaner. Insert a VideoCassette and start recording. Then, play thetape back to check the recorded image.4 If the image is still not clear, repeat Steps 1 to3. (Do not use the Head Cleaner 3 times ormore consecutively.)Notes:≥Do not rewind every time you use the Head Cleaner.Rewind only when the tape reaches the end, and then useit again from the beginning in the same manner as before.≥If the heads become dirty soon after cleaning, the tape maybe damaged. In this case, immediately stop using thatCassette.≥Do not clean the heads excessively. (Excessive cleaningmay cause excessive wear of the heads. If the heads areworn, images cannot be played back even after the headsare cleaned.)≥If the dirty heads cannot be cleaned with the head cleaner,the Palmcorder needs to be cleaned at a service center.Please consult a distributor or Panasonic Service center.≥Video head cleaners can be purchased from servicecenters.≥Head cleaning due to dirty heads is not considered amalfunction of the product. It is not covered by thewarranty.Periodic Check-upTo maintain the highest image quality, we recommendreplacement of worn parts, such as heads, etc., afterapproximately 1000 hours of use. (This, however, dependson operating conditions, such as temperature, humidity,dust, etc.)ª Optimal Use of the BatteryBattery CharacteristicsThis Battery is a rechargeable lithium ion battery. Its ability togenerate power is based upon the chemical reaction thattakes place inside it. This reaction is affected by thesurrounding temperature and humidity, and, if thetemperature is too high or too low, the operating time of theBattery becomes shorter. If the Battery is used in anextremely cold environment, the Battery may operate onlyfor about 5 minutes. If the Battery becomes extremely hot, aprotective function may operate, and the Battery may evenbecome unusable for a while.Be Sure to Detach the Battery After UseBe sure to detach the Battery from the Palmcorder. (If it isleft attached to the Palmcorder, a minute amount of currentis consumed even when the Palmcorder power is off.) If theBattery is left attached to the Palmcorder for a long time,over discharge takes place. The Battery may becomeunusable after it is charged.Disposing of an unusable Battery≥The Battery has a limited life.≥Do not throw the Battery into fire because it may cause anexplosion.Always Keep the Terminals of the Battery CleanPrevent the terminals from getting clogged with dirt, dust, orother substances.If you drop the Battery accidentally, check to see if theBattery body and terminals are damaged.Attaching a damaged Battery to the Palmcorder or ACAdaptor may damage the Palmcorder or AC Adaptor.