15VQT0T50∫ About the SD Memory Cards that you can use¢ The recording may suddenly stop during motion picture recording. (P35)∫ About the SD card≥ Do not touch the terminals on the back of the SD card.≥ Electrical noise, static electricity, or failure of this unit or the SD card may damage orerase the data stored on the SD card. We recommend saving important data on aPC by using the USB cable (supplied) or MotionSD STUDIO. (P73) (When savingimages recorded using this unit to a PC, you must use MotionSD STUDIO. )≥ When using an SD card on which data has been written many times, the remainingtime left for recording may be reduced. (P35)∫ About the card access lamp≥ When this unit accesses the SD card (reading, recording, playback, erasing, etc.),the access lamp lights up.≥ If the following operations are performed when the access lamp is lit, then the SDcard or the recorded data may be damaged or this unit may malfunction.– Opening the card slot cover and inserting or removing the SD card.– Operating the [ON/OFF] switch or the mode dial.∫ About the write protection switch on the SD Memory Card≥ The SD Memory Card has a write protection switch 1 on it. If theswitch is moved to [LOCK], you cannot write to the SD card,delete the data on it or format it. If it is moved back, you can.Recording modeSD card capacity8 MB, 16 MB 32 MB, 64 MB,128 MB256 MB, 512 MB, 1 GB,2 GB (Maximum)Motion picturerecording modeCannot beused.Cannot beguaranteed inoperation¢Refer to page 34.Still picturerecording modeCan be used.21
