– 140 –Chapter 11 Network Connection — Connecting the remote operation panel (AK-HRP200G)f Digital extender display : Disabledr When the [MENU] → [CAMERA SETTINGS] → [Enhanced] → [Enhanced SW] is set to [OFF]Following buttons are disabled in addition to limitation when [Enhanced SW] is set to [ON].f Matrix button f Skin tone detail button f Detail off button f Detail volume f RGain volume f BGain volume f RFlare/pedestal volume f BFlare/pedestal volume f Master pedestal volume About adjusted value display area (4 digits)Zoom, focus, and auto focus are not supported.When the VFR is set to [ON], it is displayed as [***P] (*** is the frame rate value).When the VFR is set to [OFF], it is displayed as [FroF].When the setting of the camera is set to [Native ISO] or [ISO], it is displayed as [iSo].@@ NOTEt To connect the camera and AK-HRP200G directly, use a crossover LAN cable.t For details, refer to the Operating Instructions of AK-HRP200G.t The following information is required to connect to AK-HRP200G.- User account name- Password- IP address- Port number: 49152t For AK-HRP200G, use Ver4.01.00 or later versions.t For details on the operations of ROP setup software application, refer to the Operating Instructions of AK-HRP200G.t For the ROP setup software application, use Ver3.0.0.0 or later versions.
