– 65 –Chapter 6 Audio recording — Selecting audio input and adjusting recording levels2 From [SYSTEM] → [AUDIO], set [AUDIO IN].For [CH3/4], switch to [CH1/2] in [to CH1/2].3 Select [MANUAL] in [FRONT1 LEVEL] or [FRONT2 LEVEL].If [AUTO] is selected, [A] is displayed on the [VOL] screen and manual adjustment is not possible.4 Select [AUDIO VOL] in [SYSTEM] → [AUDIO].5 Adjust with [FRONT1+]/[FRONT1−] or [FRONT2+]/[FRONT2−] or turning the jog dial while viewing the display of the audio channellevel meter.When the topmost bar (0 dB) is exceeded, the red bar display lights up to indicate that input volume is excessive. Adjust the maximum level so thatthe display does not reach 0 dB.The levels for both channels will increase or decrease with the jog dial operation. It will not increase or decrease in case of [AUTO].r Recording standard levelIn [MENU] → [SYSTEM SETTINGS] → [AUDIO LEVEL] → [HEADROOM], [18dB] or [20dB] can be selected.Common settings for channels 1 through 4.@@ NOTEt When the level adjustment is set to [MANUAL], set whether to enable [FRONT1 LIMITER]/[FRONT2 LIMITER]/[REAR1 LIMITER]/[REAR2 LIMITER]in [MENU] → [SYSTEM SETTING] → [SYSTEM MODE] → [AUDIO LEVEL]. This is set to [OFF] in the factory settings.Audio monitor (headphones)You can listen to the camera’s audio using headphones.1 Press the button to display the HOME screen.2 From [SYSTEM] → [AUDIO], select [AUDIO OUT].r Setting the headphones output audio1 Select the output signal (mono, stereo, mix) in [MONITOR].r Adjusting the headphones output audio level1 Adjust with [MON+]/[MON−] or turning the jog dial.
