– 99 –Chapter 9 Other Useful Functions — Connection through the terminalConnection through the terminalConnecting to a computer in the USB device modeConnecting to a computerFig. 11 Connect the USB cable to the terminal (device). (Fig. 1)2 Set the [MENU] → [SYSTEM SETTINGS] → [INFORMATION] to [USB].For details, refer to “Setting menu basic operations” (page 102).During USB connection, [USB DEVICE CONNECTED] is displayed in the center of the control panel.If it is not connected properly, [USB DEVICE DISCONNECTED] is displayed.3 Exit the USB device mode.There are following two methods:f Turn the power switch of the camera to .f Press the button.@@ NOTEt The USB 2.0 cable is not supplied with the camera. Prepare a commercial USB 2.0 cable (double-shielded for noise suppression).t A USB connection cable of up to 5 m is supported, however, a cable of 3 m or shorter is recommended as preferable.t When the camera is operating in the USB device mode, no camera shooting, recording/playback operation or clip thumbnail operation is allowed.t When the camera is operating in the USB device mode, the P2 card remaining capacity and status are not displayed. Also, video/audio cannot beoutput or displayed.
