Panasonic WJ-HL208A Operating Instructions Manual

Also see for WJ-HL208/G: Operating instructions

Contents

Panasonic WJ-HL208A Operating Instructions Manual Manual pdf 18 page image

189 Monitor Output Connector(VGA)A VGA connector is provided so that you can use a standard, multi-synccomputer monitor as your main monitor. Use the cable supplied with yourmonitor to connect it to the recorder.Connect the spot monitor to the [SPOT] connector as needed.Note: Connect the monitor before the recorder boots so that video can be displayed on the monitorwith the resolution you have set during system setup.: Network PortThe recorder can be networked using the 10/100/1000 Mbps Ethernet connector. Connecta Cat5 cable with an RJ-45 jack to the recorder connector. The recorder can be networkedwith a computer for remote monitoring, searching, configuration and software upgrades. See“Chapter 3 ─ Configuration” for configuring the Ethernet connections.Important: The network connector is not designed to be connected directly with cable or wireintended for outdoor use.; Power InletConnect the provided AC power cord to the recorder and then to a wall outlet.WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD. MAKE CERTAINTHE POWER CORD WILL NOT BE PINCHED OR ABRADED BY FURNITURE. DO NOTINSTALL POWER CORDS UNDER RUGS OR CARPET.THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT HAVEA GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT OVERLOAD THECIRCUIT BY PLUGGING TOO MANY DEVICES IN TO ONE CIRCUIT.Your recorder is now ready to operate. Refer to “Chapter 3 ─ Configuration” and “Chapter 4 ─ Operation”.