Panasonic WJ-HL208A Operating Instructions Manual

Also see for WJ-HL208/G: Operating instructions

Contents

Panasonic WJ-HL208A Operating Instructions Manual Manual pdf 31 page image

31Highlighting “Schedule On” and pressing the buttontoggles On and Off. When set to On, you can select the day,time range and interval that you want the recorder to run self-diagnostics on the recorder.The “Interval” can be selectable from “1 min.” to “7 days” or“Never”.Highlight the “+” and press the button to add a scheduleitem. The “ ” box allows you to delete a check recordingschedule.Figure 25: Check Recording screenHighlight the “Settings” box beside “Check Alarm-In” and press the button. You can select the intervalthat you want the recorder to run self-diagnostics on Alarm Inputs. You can select from “1 hr.” to “30 days” or“Never”.Highlight the “Settings” box beside “Disk Almost Full”, and press the button. Select the percentage level ofdisk usage at which you want the recorder to trigger an alert. Percentage levels range from 80 % to 99 %.Highlight the “Settings” box beside “Disk Bad”, and press the button. Select percentage level of bad disksectors at which you want the recorder to trigger an alert. Percentage levels range from 10 % to 90 %.Highlight the “Settings” box beside “Disk Temperature”, and press the button. Select the temperatureof hard disk drive at which you want the recorder to trigger an alert if the temperature exceeds the definedthreshold. Refer to the hard disk drive manufacturer’s documentation for the correct temperature setting.The recorder can be set to react to system events. Highlight the “Actions” box beside the desired event andpress the button. System events can be associated with an Alarm-Out connector, sound the recorder’sinternal buzzer, and/or notify a number of different devices.Note: “Alarm-Out” action cannot be set to “System”, “Boot Up”, “Restart”, “Shutdown” and “PanicRecord” events. “Mail” notify is the only option available for the “System Event”. “AlertWindow” notify cannot be set to “System”, “Boot Up”, “Restart” and “Shutdown” events.