Panasonic WJ-NT104 Operating Instructions Manual

Also see for WJ-NT104: Operating instructions Operating instructions

Contents

Panasonic WJ-NT104 Operating Instructions Manual Manual pdf 38 page image

38Alarm activated Time baseSet delay timeContinuous recordingAlarm activatedBefore continuousrecordingAfter continuousrecordingTime baseAlarm activated Single Frame Recording Time baseSet delay timeDiffers depending on resolution and picture quality.Super Fine/Fine Normal/Rough640 x 480 16 images 24 images640 x 240 40 images 58 images320 x 240 89 images 123 images160 x 120 255 images 255 imagesMaximum number of recorded alarm images ALARM RecordingThe WJ-NT104 records images before and after an alarm is activated and notifies the user of alarm input. Alarm imagescan be recorded in the following three modes: Single Frame Recording modeWhen an alarm is received, the alarm image is captured and saved as a still image after the specified delay time.• The delay time from receiving an alarm until capture of the alarm image can be specified in the range of 0 to 10 sec-onds in increments of 100 ms. Continuous Recording [after alarm] modeWhen an alarm is received, the specified number of alarm images are captured and saved after the specified delay time.• The delay time from receiving an alarm until capture of the alarm image can be specified in the range of 0 to 10 sec-onds in increments of 100 ms.• The number of images to save can be set to between 1 and 16 (resolution 640 x 480).• A frame rate of 1/10, 1/5, 3/10, 1/2, 1, 2, 3, 5, or 10 can be selected.• If another alarm is received while recording an alarm, the on-going alarm processing is suspended and the new alarmimage is recorded with priority over the preceding one. Continuous Recording [before/after alarm] modeImages before receiving an alarm are recorded at the preset frame rate and in the preset number of images. After analarm is activated, the specified number of images are continuously captured and saved.• The total number of images to be saved before and after an alarm can be set to between 1 and 16 (resolution 640 x480).• A frame rate of 1/10, 1/5, 3/10, 1/2, 1, 2, 3, 5, or 10 can be selected. (Frame rate 10 is not available for recordingbefore an alarm event.)• If another alarm is received while recording an alarm, the on-going alarm processing is suspended and the new alarmimage is recorded with priority over the preceding one.Note: This mode is valid only in Fixed Input Selectionmode is selected.