Panasonic WJ-NT104 Operating Instructions Manual

Also see for WJ-NT104: Operating instructions Operating instructions

Contents

Panasonic WJ-NT104 Operating Instructions Manual Manual pdf 54 page image

54UTILITY SOFTWARE Network SetupFor the network setup, you need to set the IP addressusing the Utility Software provided and connect the WJ-NT104 to a PC via the RS-232C port. ConnectionThe COM1 port of the RS-232C interface is used forsetting the IP address. Your PC should be IBM-PCcompatible, have Windows95, Windows98 or WindowsNT4.0 installed, and have an RS-232C port.Before installing the Utility Software provided, read theReadme.txt file on Utility Software disc.q Connect the RS-232C port on the front of the WJ-NT104and the RS-232C port of the PC with an RS-232Ccable.w Set bits #7 and #9 of the MODE selector to ON position(leave the others on OFF), and then press the RESETbutton on the front of the WJ-NT104.e Click the Start button, point to Programs and then WJ-NT104 Utilities, then click Network Configuration.r To set the IP address: Enter the IP address into the [IPADDRESS] fields of the dialog box, then click the[SET] button. If the IP address has been set properly,the response command REI and the IP address enter-ed (in hexadecimal, 8-bit notation, e.g., REI:COA8000Afor IP address 192.168.0.10) should appear in the WJ-NT104 RESPONSE field. If a wrong number is shown,click the [SET] button again.t To set the netmask: Enter a set value into the [NET-MASK] fields of the dialog box, then click the [SET]button. If the netmask has been set properly, theresponse command REM and the set value entered (inhexadecimal, 8-bit notation, e.g., REM:FFFFFF00 forthe set value 255.255.255.0) should appear in the WJ-NT104 RESPONSE field. If a wrong number is shown,click the [SET] button again.y To set the default gateway: Enter a set value into the[DEFAULT GATEWAY] fields of the dialog box, thenclick the [SET] button. If the default gateway has beenset properly, the response command REG and the setvalue entered (in hexadecimal, 8-bit notation, e.g.,REG:COA80001 for the set value 192.168.0.1) shouldappear in the WJ-NT104 RESPONSE field. If a wrongnumber is shown, click the [SET] button again.u Complete the setup by clicking the [EXIT] button.i Return all switches on the MODE selector to OFF posi-tion and then press the RESET button on the front of theWJ-NT104.This completes setup and return to the normal applica-tion mode.PCRS-232C cableWJ-NT1049-pin D-sub connector(female)9-pin D-sub connector(female)12345678Frame12345678FrameShield