Click “Preset per sender >>” to open a separate window for setting preset positions for alarms.(®page 103)• Default: Off[Image compression rate upon alarm detection]Click “Image compression rate upon alarm detection >>” to display the setup menu that can configure thesettings relating to image quality when an alarm occurs. The setup menu will be displayed in a newly openedwindow. (®page 104)[Alarm E-mail notification]Click “E-mail server >>” to display the setup menu that can configure the settings relating to E-mail notificationwhen an alarm occurs. The setup menu will be displayed in a newly opened window. (®page 105)[Alarm image FTP transmission]Click “FTP >>” to display the setup menu that can configure the settings relating to FTP transmission when analarm occurs. The setup menu will be displayed in a newly opened window. (®page 106)[Panasonic alarm protocol]Click “Panasonic alarm protocol notification >>” to display the setup menu that can configure the settingsrelating to transmitting Panasonic alarm protocol notifications when an alarm occurs. The setup menu will bedisplayed in a newly opened window. (®page 107)[HTTP alarm notification]Click “HTTP alarm notification >>” to display the setup menu that can configure the settings relating totransmitting HTTP alarm notifications when an alarm occurs. The setup menu will be displayed in a newlyopened window. (®page 108)10.2.1 Configure the settings relating to Preset per sender (“Presetper sender” setup menu)On the [Alarm] tab of the “Alarm” page (®page 101), click “Preset per sender” for “Command alarm”.The sender’s address for the command alarm, and the preset position for that address can be registered inthis section.[Sender's address 1] - [Sender's address 8]Set the sender’s IP address for the command alarm, and the preset position for that address. Up to 8 notificationaddresses can be set.[Auto track cooperation] checkbox: When the checkbox is selected, auto tracking starts after the directionof the camera moves to the preset position.Operating Instructions 10310 Configure the alarm settings [Alarm]
