[Panning 0° direction setting]Configure the Panning 0° direction setting. When the [Set] button is clicked after adjusting the angle of viewwith the control pad/buttons, the current direction of the pan becomes 0°. Click the [Reset] button to reset tothe default setting.Note• The tilt 0° angle is not configured.• Even if the Panning 0° direction is changed, there is no change to the preset positions alreadyconfigured. The range of the auto pan setting and the actions of the patrol setting already configuredare also not changed.• Thumbnail images displayed before and after changing the Panning 0° direction for the 360 map-shotfunction are changed.[Zoom] buttons, [Focus] buttons, [Brightness] buttons, Control pad/buttons and [Go] buttonRefer to page 10 for descriptions of how to operate these buttons/pad.[Close] buttonClick this button to close the “Direction/Angle setting” setup menu.8.5.8 Configure the settings relating to the privacy zone (“Privacyzone” setup menu)Click the [Setup>>] button of “Privacy zone” on the [Image/Position] tab of the “Image/Audio” page(®page 58).When there is a zone that you do not want to display, set the zone as a privacy zone not to be displayed.According to the setting of “Number of Privacy zone”, up to 8 or 32 privacy zones can be set. (®page 56)You can set the areas by dragging the mouse on the screen.Note• The privacy zone function does not work when the camera is in the process of warming-up just afterturning on the power, or in the process of refreshing the position.• Depending on the panning/tilting direction (especially when the tilting degree is 45° - 90°) and thezooming factor, the area set as the privacy zone may become visible. Make sure that each of the setprivacy zone is not visible after setting it.Operating Instructions 858 Configure the settings relating to images and audio [Image/Audio]
