4. Configure the settings of Camera 2 (IP address: 192.168.0.12), which receives notification commands fromthe other cameras.Display the “Alarm” screen from the “Alarm” page. (®page 99)From “Alarm”, set “Command alarm” to “On” and click the [Set] button.Set the “Command alarm” of “Camera action on alarm” to “Preset per sender”, and click “Preset persender >>”.On the “Preset per sender” setup menu (®page 103), check the “Auto track cooperation” checkboxof “Sender's address 1” (any destination address can be used) and enter 192.168.0.11 (Camera 1) forthe sender’s address. Then select the preset position set at step 2, click the [Set] button, and then closethe page.Click the [Set] button.5. Auto track cooperation can be used by starting the auto tracking for Camera 1.8.5.7 Configure the settings relating to direction/angle setting(“Direction/Angle setting” setup menu)Click the [Setup>>] button of “Direction/Angle” on the [Image/Position] tab of the “Image/Audio” page(®page 58).Here the information related to the direction/angle setting is set. The pan/tilt position moves to the position setas north when displaying this page.Direction/Angle setting[North point setting]If “Direction display” is selected for “Camera position display”, one of the eight directions will be indicatedinstead of the preset position title when the camera is not at the preset position.Determine the direction setting by adjusting the displayed panning position to the north (N) indication.84 Operating Instructions8 Configure the settings relating to images and audio [Image/Audio]
