[Close (Up to 5 characters)]Enter the name for “Close” of “AUX” on the “Live” page.• Unavailable characters: " &• Default: CloseNote• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.For example, an operator can remotely control lights in a place where the camera is installed byconnecting the terminal to the light controller.10.5 Configure the VMD settings [VMD area]Click the [VMD area] tab on the “Alarm” page. (®page 32, page 34)The video motion detection areas can be set on this page.The VMD areas can be set up to 4 areas for each preset position (maximum 256 preset positions). Whenmotion is detected in the set area, the alarm operations will be performed. The camera can be configured totake an alarm action even when the camera is not at the preset position.IMPORTANT• The alarm occurrence indication button (®page 10) will be displayed when motion is detected by theVMD function.• The alarm occurrence indication button will be displayed when receiving a command alarm.• Depending on the network environment, notification may be delayed even when “Real time” is selectedfor “Alarm status update mode” on the [Basic] tab of the “Basic” page (®page 38).• After configuring the VMD area, the VMD area may move out of alignment when the JPEG/H.264“Image capture mode” setting is changed. Make sure to check the VMD area after changing the “Imagecapture mode” setting.• If “Start” is selected after selecting a setting other than “Stop” for [Wiper] on the “Live” page duringwiper operations, alarm operations will not be performed. The alarm occurrence indication button onthe VMD area setting screen will also not be displayed. Stop wiper operations when configuring alarmsettings.110 Operating Instructions10 Configure the alarm settings [Alarm]
